Raypak 181/182, 260/261, 400/401, 330/331 manual Tabs Beforeafter

Page 5

7.Mount the Power Vent on the outer top.

8.Route the conduit harness of the Power Vent thru the outer top hole, around the adapter towards the back of the unit. Continue routing the harness thru the corner slot, which leads to open area behind the access panel. Finally, route only the wire harness thru the 7/8” grommet hole located on the sway brace. Follow instructions on page 7 to wire the Power Vent. Note: Newer units have a 7/8” grommet located on the rain shield, which would eliminate routing the harness around the back corner.

9.Re-mount the jacket top to its original position and screw in the four screws holding it down to the appli- ance.

10.If the appliance is a 181, 182, 330 or 331, remove the tabs underneath the power vent using a 5/16” nut driver and relocate them closer to the center of the Power Vent as shown in Fig. 1.

11.Mount the Power Vent assembly bottom on the 6” vent as shown below. Twist the assembly downward. Snap the mounting brackets into their appropriate slot

TABS

BEFOREAFTER

Fig. 1: Reposition the Tabs as Necessary (see step 10)

to hold the Power Vent in position. Note: While twisting you may notice some roughness, this is due to a tight seal between the 6” vent and the Power Vent flue box.

12.Re-mount the access panel.

13.Re-mount the front door along with the knurled screw on the heater.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

EXHAUST

 

TOP VIEW

 

 

 

 

 

 

 

 

 

OUTLET

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

REAR VIEWLEFT SIDEFRONT VIEW

Note: The 90° elbow may be used as a termination cap.Fig. 2: Draft Assembly 5

Image 5
Contents Power Vent Page Contents Receiving Equipment General SpecificationsInstallation Tabs Beforeafter Table B Vent/Air Inlet Termination Clearances Left Side Relay GAS Wiring Diagrams-182-260 H4/WH1 Atmospheric 181-261 H4/WH1 Low NOx Wiring Diagrams-330-400 H4/WH1 Atmospheric 331-401 H4/WH1 Low NOx See Table D for Dimensional Data Sequence of Operation Start Up ProceduresDraft Proving Switch 330-401 Illustrated Parts List

330/331, 400/401, 181/182, 260/261 specifications

Raypak is a leading manufacturer in the pool and spa heating industry, known for its innovative and tech-savvy products. Among its offerings, the Raypak 260/261, 181/182, 400/401, and 330/331 series of heaters stand out due to their advanced features and characteristics.

The Raypak 260/261 series is designed specifically for residential and commercial pools. One of its main features is its digital control system, which ensures precise temperature settings and improved energy efficiency. With a maximum output of 260,000 BTUs, this series is perfect for heating larger pools, providing quick warm-up times and consistent heat levels, making swimming enjoyable even in cooler months. The 260/261 series also incorporates a unique low NOx design for environmentally friendly operation, adhering to strict emissions standards.

Next in line, the Raypak 181/182 series is known for its compactness and efficiency. With an output of 180,000 BTUs, this heater is perfect for smaller residential pools and spas. It features a bronze header design which resists corrosion, enhancing its longevity. Additionally, the direct spark ignition system contributes to reliability and ease of use, ensuring a quick startup without the need for a pilot light.

The Raypak 400/401 series caters to high-demand scenarios where quick heating is crucial. With an impressive heating capacity of up to 400,000 BTUs, it is designed for commercial applications, such as hotels and water parks, as well as large residential installations. This series is equipped with advanced digital control technologies, allowing for easy monitoring and adjustment of settings. The built-in stainless steel burner, combined with a robust heat exchanger design, enables efficient thermal performance and extended service life.

Lastly, the Raypak 330/331 series provides a well-balanced option for those seeking power and efficiency. With heating outputs of 330,000 BTUs, this series combines the latest in heat exchanger technology with a user-friendly interface. It also features Raypak’s signature low NOx emissions technology, making it suitable for compliance with regional air quality regulations.

In summary, Raypak's various heater series, including the 260/261, 181/182, 400/401, and 330/331, offer a diverse selection of features tailored for different heating needs. With a strong emphasis on performance, efficiency, and environmental responsibility, Raypak continues to be a dominant player in the pool and spa heating industry.