Raypak D2 manual Power Vent

Page 1

INSTALLATION & OPERATING

INSTRUCTIONS

D-2

Power

Vent

For 181/182, 260/261, 330/331 &

400/401 – Boilers & Water Heaters

WARNING: If these instructions are not followed exactly, a fire or explosion may result causing property damage, personal injury or death.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids or other combustible materials in the vicinity of this or any other appliance. To do so may result in an explosion or fire.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

This manual should be maintained in legible condition and kept adjacent to the heater or in another safe place for future reference.

CATALOG NO. 6000.57F

Effective: 12-02-08

Replaces: 5-20-08

P/N 241086 Rev. 7

Image 1
Contents Power Vent Page Contents Pay Attention to These Terms Installation General SpecificationsReceiving Equipment Tabs Before After Table B Vent/Air Inlet Termination Clearances Venting Left SideLeft Side Wiring Diagrams-182-260 H4/WH1 Atmospheric 181-261 H4/WH1 Low NOx Data Draft Proving Switch Start Up ProceduresSequence of Operation Call Out Description 181-261 331-401 Illustrated Parts List