Maytag SXS 111107-1, 61004966 Storing the Refrigerator, Care and Cleaning, Vacations, Moving

Page 10
Storing the Refrigerator

Storing the Refrigerator

Vacations

d)

clean and dry the refrigerator thoroughly,

If you will be gone for a month or less, leave the con-

e)

leave the doors open to prevent odors.

 

 

trols at the usual settings.

 

 

During longer absences:

a)remove all food,

b)shut off the ice maker (if installed) and the valve where you tapped into the water line to supply the refrigerator,

c)disconnect the refrigerator from the electrical outlet,

Care and Cleaning

Moving

When moving, follow steps a–d under Vacations. In addition, remove and carefully pack any items that are easily removable. Ship the refrigerator in an upright position with the doors taped shut.

Refer to the chart on the following page for specific refrigerator cleaning guidelines.

Disconnect the power cord before cleaning.

Cleaning Under the Refrigerator

Your refrigerator can be rolled out for cleaning the floor underneath. Raise the locking feet if engaged (see page 2). Pull the refrigerator straight out from the wall.

No Clean™ Commercial-duty Condenser

A clean condenser means more efficient refrigerator operation. Thanks to the unique design of the No Clean™ condenser, there is no longer a need for routine condenser cleaning in normal home usage surround- ings.

Some operating environments may be particularly dusty or greasy. In these situations, the condenser can be periodically cleaned to insure maximum efficiency.

Replacing a Light Bulb

VacationsCAUTION: Disconnect the power cord before replacing light bulb(s). Wear gloves as protection against possible broken glass.

Always use a standard 40 or 60 watt appliance bulb.

Refrigerator

To replace a light bulb at the upper rear, unscrew the bulb located in the center opening on the bottom of the control cover. The replacement bulb can then be screwed in. If more access is required for bulb replace- ment, grasp the control cover in the two lower rear “finger tabs”, pull down slightly to clear retainer tabs and slide the cover forward until it is free. After replac- ing the bulb, align the control cover on to the ribs and slide it straight back until it snaps onto the retainer tabs.

Freezer (Select Models)

(1)unhook the tabs on the top of the light shield by pressing in with the thumb on the center top of the light shield; (2) pivot the shield down; (3) unscrew the bulb when cool and replace with a standard 40 watt appliance bulb; (4) pivot the shield up into place, snap- ping the tabs into the slots.

Dispenser Light (Dispenser Models Only)

For replacement, use a 120V, 7 watt bulb. Disconnect the power cord before replacing the light bulb.

9

Page 9 Page 11
Image 10
Page 9 Page 11
Contents USER’S GUIDE Table of ContentsSide by Side Refrigerator For Future Assistance Important Safety InstructionsSAVE THESE INSTRUCTIONS Location InstallationLeveling Temperature Controls Step Initial Temperature Control SettingsStep Adjusting the Temperature Controls No DefrostingStorage Drawers Looking InsideShelves WARNING - Never attempt to adjust a shelf that is loaded with foodEnergy Saving Tips Automatic Ice Maker Ice ServiceTo remove the ice bin Ice and Water Service Automatic Ice and Water DispenserFrozen Food Storage Food Storage TipsFresh Food Storage Do not refreeze meat that has completely thawedNo Clean Commercial-duty Condenser Care and CleaningCleaning Under the Refrigerator Storing the RefrigeratorTips and Precautions Refrigerator Cleaning ChartCleaning Agents Refrigerator ExteriorBefore You Call Check these points if your refrigeratorFull One Year Warranty Refrigerator WarrantyTo Receive Warranty Service Limited Warranty - Major Refrigeration ComponentsMAYTAG 403 W. 4th Street N. P.O. Box 39 Newton, Iowa
Top Page Image Contents