Remove Duct Knockouts | GE JV535 specification

Installation Instructions

8REMOVE DUCT KNOCKOUT(S)

If recirculating, non-vented ductless (optional for JV5 Series models only), see note below and skip to Step 11 D and proceed. We do not recommend the recirculated configuration for JV6 Series models.

Using a flat blade screwdriver, remove the appropriate duct knockout(s) from the top or back of the hood.

9FOR 31⁄4″ X 10″ RECTANGULAR

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Attach exhaust adaptor/damper over knockout opening with two exhaust adaptor screws. Make sure damper pivot is nearest to top/back edge of hood. Remove tape from damper flap.

31⁄4″ x 10″ Rectangular vertical discharge. Remove top rectangular duct knockout only.

7″ Round vertical discharge. Remove semi- circular duct knockout and top rectangular duct knockout.

31⁄4″ x 10″ Rectangular horizontal discharge. Remove rear rectangular duct knockout only.

Up to 1″ side-to-	Tape
side adjustment
Pivot	Top/back edge
Pivot
	Exhaust adaptor/damper
	(vertical discharge position
	shown)

NOTE: The exhaust adaptor/damper can be installed up to 1 inch on either side of the hood center to accommodate off-center ductwork. In extreme off- center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

NOTE: If the hood is to be installed in a recirculating, non-vented ductless manner, order kit number WB02X10707 for 30″ hood models, or kit number WB02X10708 for 36″ hood models. These kits can

be ordered from your GE supplier. Skip to Step 11 D and proceed.

10FOR 7″ ROUND VERTICAL

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Re-install the 7″ round exhaust adaptor with its screws, removed in Step 2 under the “Prepare the Hood” section.

7″ round exhaust adaptor

NOTE: The 7″ round exhaust adaptor can be installed up to 1″ on either side of the hood center to accommodate off-center ductwork. In extreme off-center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.