GE Profile 30 Telescopic Downdraft System

PVB94SN

GE Profile™ 30" Telescopic Downdraft System

Dimensions and Installation Information (in inches)		Venting Options (in inches)
	8-1/2	Through the Floor	In Cabinet Discharge (Down)
	8-1/2	Through the Floor	In Cabinet Discharge (Down)

2-1/8*

2-1/2" MIN.**

In Cabinet Discharge (Right)

In Cabinet Discharge (Left)

28-1/2

See table

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Note: Telescopic downdraft vents are not recommended to be installed with cooktops that are flush mounted.

Approved for use with the following GE Profile Performance™, GE Profile™, and GE cooktops–36" and 30" electric models, 36" and 30” gas sealed burner models and 36" and 30" induction models.

Not Approved for use with standard burner gas cooktops.

Note: The cooktop must be at least 26" deep with a flat surface area of 23-1/2" or more, front to back. In addition, other clearances to the front edge of the countertop must be considered.

Note: Dimensions shown are for reference only. Before cutting out countertop, refer to instructions packed with downdraft and cooktop.

Note: Installation on cabinets/countertops against the wall will not be possible in most applications. Against the wall installations are limited to dimension requirements. Refer to installation instructions packed with product for further details.

JXBC67 Outdoor Cover. Optional accessory may be ordered for installation of motor and blower assembly on outside wall.

JXRB67 Indoor Remote Accessory. Optional accessory may be ordered for installation of motor and blower assembly in an indoor remote location.

Listed by

Underwriters

Laboratories

Specification Created 9/08

220965

PVB94SN