Stainless, Steel surfaces, Painted Surfaces, Light bulbs

		Care and Cleaning

			Chimney Vent Hood

Stainless	'RQRWXVHDVWHHOZRROSDGLWZLOOVFUDWFKWKH	After cleaning, use a stainless steel polish, such
steel surfaces	surface.	as Stainless Steel Magic®, Revere Copper and
(on some models)	To clean the stainless steel surface, use warm	Stainless Steel Cleaner® or Wenol All Purpose
(on some models)	sudsy water, a stainless steel cleaner such as	Metal Polish®. Follow the product instructions for
	Kleen King® or an all-purpose liquid or spray	cleaning the stainless steel surface.
	cleaner. Always scrub in the direction of the grain.
	Rinse thoroughly with a sponge or cloth and clean
	water. Dry with a soft, clean cloth.

Painted

Clean any painted surfaces with a mixture of	Do not use commercial oven cleaners, cleaning
water and either soap or vinegar.	powders, steel wool or harsh abrasives on any
	painted surface.
Pull the glass visor out and wash it with a damp
soapy cloth. Dry it with a clean cloth and push it
back into place.

NOTE: The glass cover should be removed only when cold. Wearing latex gloves may offer a better grip.

&$87,21: Before replacing the bulb, disconnect electrical power to the hood

at the main fuse or circuit breaker panel.

$77(17,21: Avant de remettre HQSODFHO·DPSRXOHGpEUDQFKH]OHFRXUDQWGHOD hotte en enlevant le fusible principal ou en faisant

Receptacle

Socket

Bulb

EDVFXOHUOHGLVMRQFWHXUDXSDQQHDXG·DOLPHQWDWLRQ

Be sure to let the light cover and bulb cool completely.

For your safety, do not touch a hot bulb with bare hands or a damp cloth.

1Insert your finger nail into the inner glass cover slot and pull down. Remove cover.

NOTE: Do not remove outer retaining ring.

2Using gloves or a dry cloth, remove the bulb by pulling it straight out.

1Use a new 12-volt, 20-watt Halogen bulb for a G-4 base.

2Using gloves or a dry cloth, remove the new bulb from its packaging.

NOTE: Do not touch the new halogen bulb with bare fingers. Touching the bulb with bare fingers will significantly reduce the life of the bulb.

Glass cover

21/<XVHDQHZYROWZDWW+DORJHQEXOEIRU D*EDVH

Receptacle

Use gloves or cloth

3Push the bulb straight into the receptacle all the way.

For improved lighting, clean the glass cover frequently using a damp cloth. This should be done when the hood is completely cool.

4Snap the glass cover into the retaining ring.

5Reconnect electrical power to the hood.