GE SCA2000BCC owner manual Hood Exhaust Duct, Filter Kit Accessory, Duct Equivalent

SCA2000BCC - GE Profile Performance™ Advantium™ Oven

Hood Exhaust Duct

Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully.

EXHAUST CONNECTION:

The hood exhaust has been designed to mate with a standard 3-1/4” x 10” rectangular duct.

If a round duct is required, a rectangular-to-round transition adaptor must be used. Do not use less than a 6” diameter duct.

REAR EXHAUST:

If a rear or horizontal exhaust is to be used, care should be taken to align exhaust with the space between studs, or wall should be prepared at the time it is constructed by leaving enough space between the wall studs to accommodate exhaust.

MAXIMUM DUCT LENGTH:

For satisfactory air movement, the total duct length of 3-1/4” x 10” rectangular or 6” diameter round duct should not exceed 140 equivalent feet.

ELBOWS, TRANSITIONS, WALL AND ROOF CAPS, etc., present additional resistance to airflow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total duct length, add the equivalent length of all transitions and adaptors plus the length of all straight duct sections. The chart below shows the approximate feet of equivalent length of some typical ducts.

Duct		Equivalent
A.	Rectangular-To-Round	5 Ft.
	Transition Adaptor
B.	Wall Cap	40 Ft.
C.	90° Elbow	10 Ft.
D.	45° Elbow	5 Ft.

Filter Kit Accessory

Grille

Filter Kit

JX81A–Recirculating Charcoal Filter Kit

To be used when the Advantium oven cannot be vented to the outside.

E.	90° Elbow	25 Ft.
F.	45° Elbow	5 Ft.
G.	Roof Cap	24 Ft.

For answers to your Monogram,®

GE Profile Performance Series,™

GE Profile™ or GE appliance questions, call

GE Answer Center® service, 800.626.2000.

Listed by

Underwriters

RLaboratories

Specification Revised 11/99