Toshiba SD-43HK owner manual Troubleshooting, Language Code List, Symptom Cause Correction

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.

Symptom		Cause		Correction
No power.	•	The power cord is disconnected.	•	Plug the power cord into the wall outlet
				securely.
The power is on, but	•	No disc is inserted.	•	Insert a disc. (Check that the DVD or,
the DVD receiver				audio CD indicator in the display
does not work.				window is lit.)
No picture.		• The TV is not set to receive DVD	•	Select the appropriate video input mode
		signal output.		on the TV so the picture from the DVD
				receiver appears on the TV screen.
	•	The video cable is not connected	•	Connect the video cable into the jacks
		securely.		securely.
	•	The connected TV power is turned off.	•	Turn on the TV.
No sound.	•	The equipment connected with the	•	Select the correct input mode of the
		audio cable is not set to receive DVD		audio receiver so you can listen to the
		signal output.		sound from the DVD receiver.
	•	The audio cables are not connected	•	Connect the audio cable into the jacks
		securely.		securely.
	•	The power of the equipment connected	•	Turn on the equipment connected with
		with the audio cable is turned off.		the audio cable.
	•	The Digital Audio Output is set to the	•	Set the Digital Audio Output to the correct
		wrong position.		position, then turn on the DVD receiver
				again by pressing On/standby(	).
The playback	•	The disc is dirty.	•	Clean the disc.
picture is poor.
The DVD receiver	•	No disc is inserted.	•	Insert a disc. (Check that the DVD, or audio
does not start				CD indicator in the DVD display is lit.)
playback.	•	An unplayable disc is inserted.	•	Insert a playable disc. (Check the disc
				type, color system and Regional code.)
	•	The disc is placed upside down.	•	Place the disc with the playback side
				down.
	•	The disc is not placed within the guide.	•	Place the disc on the disc tray correctly
				inside the guide.
	•	The disc is dirty.	•	Clean the disc.
	•	The Rating level is set.	•	Cancel the Rating function or change
				the rating level.
The remote control	•	The remote control is not pointed at the	•	Point the remote control at the remote
does not work		remote sensor of the DVD receiver.		sensor of the DVD receiver.
properly.
	•	The remote control is too far from the	•	Operate the remote control within about
		DVD receiver.		23 ft (7 m).
	•	There is an obstacle in the path of the	•	Remove the obstacle.
		remote control and the DVD receiver.
	•	The batteries in the remote control are	•	Replace the batteries with new ones.
		exhausted.

Language Code List

Enter the appropriate code number for the initial settings “Disc Audio”, “Disc Subtitle” and/or “Disc Menu” (See page 32).

MISCELLANEOUS

45 46