Care and Cleaning
Advantium Oven
Cooktop light/ night light
1.To replace the cooktop light/ night light, first disconnect the power at the main fuse or circuit breaker panel.
2.Remove the screws from the side of the light compartment cover and lower the cover until it stops.
3.Be sure the bulb(s) to be replaced are cool before removing. Break the adhesive seal by gently unscrewing the bulb(s).
Remove screws
Reusable vent filters
Replace with
4. Raise the light cover and replace the screws. Connect electrical power to the oven.
The metal filters trap grease released | For this reason, the filters must |
by foods on the cooktop. They also | always be in place when the hood is |
prevent flames from foods on the | used. The vent filters should be |
cooktop from damaging the inside | cleaned once a month, or as needed. |
of the oven. |
|
Removing and cleaning the filters
To remove, slide them to the side using the tabs. Pull down and out.
To clean the vent filters, soak them and then swish around in hot water and detergent. Don’t use ammonia or ammonia products because they will darken the metal. Light brushing can be used to remove embedded dirt.
Rinse, shake and let dry before replacing.
To replace, slide the filters into the frame slots on the side of each opening. Press up and to the side to lock into place.
39