Reversing the Door Swing
Wine Reser ve
To reverse the door
Parts included:
1.Top left case hinge
2.Bottom left case hinge
3.Left and right side decorative hinge cover
4.Decorative hinge screw hole cover
5.Torx® driver bit
Tools required:
1.Phillips screwdriver
2.Electric drill
To remove the door:
1.Flatten the shipping carton to use as a pad.
2.Remove the 2 screws and the toekick. Set aside the screws and toekick for final installation.
3.Use the supplied Torx® bit and electric drill to remove the 3 screws holding the top case hinge. Lift off the hinge. (Screws will be used to install the new hinge.)
4.Lift the door off the bottom case hinge.
5.Remove the bottom case hinge pin and bracket.
Rotate the door:
The handle will be on the right side of the door; hinges will be installed on the left side of the case.
1.Remove the doorstop and cam riser on the original bottom right side of the door.
2.Remove the fill plug on the top right side of the door.
3.Turn the door over and reinstall the fill plug on the new left side.
To reinstall the door:
1.Install the original door stop and cam riser onto the bottom left side of the door.
2.Install the new supplied bottom case hinge pin and bracket onto bottom left side.
Install
3 Hinge
Screws
Remove
Top Hinge
Hinge
Pin and
Bracket
Door Stop
and Cam Riser
Remove
Hinge
3.Place the door onto the bottom case hinge.
4.Install the supplied
5.Select the hinge cover marked with an “L”.
6.Peel backing off the tape inside the decorative hinge cover.
7. Press and snap the | Install Covers |
hinge cover into |
|
place. |
|
8.Snap the screw hole cover into place on the opposite side.
Important: Check to be sure screws are tight and that the door is straight and does not sag. The door should swing freely.
NOTE: See Installation Instructions to apply hinge cover and screw hole cover.
Position nameplate:
Apply the Monogram nameplate on the door using the template included in the installation instructions.
14