Sonic Blue EX1000 Precautions When Using Compact, Discs, Precautions When Using Audio Cassettes

Precautions When Using Compact	Before Contacting Customer Service
Discs

Handle your compact discs with care. Always hold them by the edges to avoid leaving fingerprints on the shiny surface.

When you have finished playing a compact disc, always put it back in its case.

Do not fix paper or adhesive tape to the discs and do not write on the label.

Clean discs with a special-purpose cloth.

Store your compact discs in a clean place, out of direct sunlight, where they will not be exposed to high temperatures.

Always use compact discs marked .

It always takes a little time to become familiar with a new appliance. If you have any of the problems listed below, try the solutions given. They may save you the time and inconvenience of an unnecessary service call.

Problem Checks/Explanation

• The power cord is not correctly plugged into a wall socket or the wall socket is not switched on.

The system does not work • The remote control batteries need replacing or the polarity does not match.

•The On/Standby button has not been pressed.

Precautions When Using Audio Cassettes

Check that the tape in the cassette is sufficiently taught.

To prevent erasing a cassette that you wish to keep, remove the safety tab on the upper edge of the cassette. To record a cassette, where the tab has been broken, simply cover the opening with adhesive tape.

When you have finished playing a cassette, always put it back in its case.

Store your cassettes in a clean place, out of direct sunlight, where they will not be exposed to high temperatures.

G

E

N

E

RThere is no sound

A L

The Timer does not work

If your system does not work after performing the above actions.

CThe compact disc player does not

Dstart playing

•The volume has been completely turned down.

•The correct function (TUNER, CD, TAPE, AUX) has not been selected.

•You have connected a set of earphones.

•The speaker wires have been disconnected.

•The Mute button has been pressed.

•The timer has been stopped by pressing Timer On/Off.

•Press the Sound Mode button for 5 seconds in power ‘OFF’(standby), then it is returned the original position (RESET)

•The CD function has not been selected.

•The disc has been inserted face down or is either dirty or scratched.

•The laser sensor is dirty or dusty.

•The system has not been installed on a flat, horizontal surface.

•Condensation has formed in the player; leave the system in a warm, ventilated room for at least one hour.

Avoid using 120-minute cassettes as they place unnecessary strain on the tape mechanism.

C

A

SThe tape does not start playing

TThe volume falls off

EThe cassette is not erased correctly S There is excessive flutter

R

A

DReception is poor or no radio

Istations are received at all

O

•The TAPE function has not been selected.

•The cassette has not been inserted correctly.

•The cassette player has not been closed.

•The tape is either slack or broken.

•The audio heads are dirty.

•The rollers or drive capstans are dirty.

•The tape is worn.

•The TUNER function has not been selected.

•The radio frequency has not been correctly selected.

•The antenna has been disconnected or is not facing the right way. Turn it until you find the best orientation.

•You are in a building that blocks radio waves; you must use an outside antenna.

If the above guidelines do not allow you to solve the problem, take a note of:

The model and serial numbers, normally printed on the rear of the system

Your warranty details

A clear description of the problem

Then contact your local dealer or Customer Service.

22