GE ZIFP360NX dimensions Cutout and Clearances for Multiple Product Installations

ZIFP360NX

GE Monogram® 36" Built-In Professional All-Freezer

Dimensions and Installation Information

Cutout and Clearances for Multiple Product Installations

ZUGPP2: For side-by-side installation of two professional models. This kit provides a unified stainless steel grille panel to span the width of two units.

For a complete food storage center, install a Monogram All-Refrigerator and All Freezer side-by-side. For even more capacity, install two refrigerators or two freezers.

				0"
	25"						25"
Min.		to				Min. to
Wall			130° Door Swing		130° Door Swing	Wall

If you are installing two units, side by side, the installation space must be 71-1/2" wide. Additional cutout width may be required when side panels are used. Add side panel thickness to the finished cutout to calculate rough-in width.

•The water and electrical locations for each product must be located as shown.

•A separate 115V, 60Hz., 15 or 20 amp power supply is recommended for each product.

5"

Clearances for Multiple Single Door Installations

In a side-by-side installation of a left and right door swing product, the inside trims touch at the front, with a 1" clearance between the units at the rear. Order ZUGPP2 Professional Unified Grille Panel Kit for one continuous grille panel.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Clearances for two products installed side-by-side with right and left side hinges together

Allow 5" minimum between the two products to prevent one door from striking the other. Use the WX14X99 adjustable door stop to reduce the factory set 130˚ door swing and to allow pan removal. NOTE: A unified grille panel kit will NOT fit this installation.

Listed by

Underwriters

Laboratories

Specification Revised 10/09 110151