PS978STSS
GE Profile™ Slide-In Double Oven Electric Range
Dimensions and Installation Information (in inches)
KW Rating
240V | 14.4 |
|
|
208V | 10.8 |
|
|
Breaker Size | |
|
|
240V | 40 Amps |
|
|
208V | 40 Amps |
|
|
Note: To reduce the possibility of scorching the side walls above the countertop when no load is present on burners, it is recommended that a minimum 6" spacing from adjacent side wall be allowed for possible extended
Receptacle Locations: For all 30"
Minimum dimensions between cooktop, walls and above the cooktop:
A. Make sure the wall covering, countertop, flooring and cabinets around the range can withstand the heat (up to 200°F) generated by the range.
B. Allow 30" minimum clearance between surface units and bottom of unprotected wood or metal cabinet, or allow a 24" minimum when bottom of wood or metal cabinet is protected by no less than 1/4" thick flame retardant millboard covered with not less than No 28 MSG sheet metal, (.015"), .015" thick stainless steel, .024" aluminum or .020" copper. Acceptable electrical outlet area. Orient electrical receptacle so the length is parallel to floor.
C. This appliance has been approved for 0" spacing to adjacent surfaces above the cooktop. However, a 6" minimum spacing to surfaces less than 15" above the cooktop and adjacent cabinet is recommended to reduce exposure to steam, grease splatter and heat. To reduce the risk of burns or fire when reaching over hot surface elements, cabinet storage space above the cooktop should be avoided. If cabinet storage space is to be provided above the cooktop, the risk can be reduced by installing a range hood that projects at least 5" beyond the front of the cabinets. Cabinets installed above the cooktop must be no deeper than 13".
Installation information: Before installing, consult installation instructions packed with product for current dimensional data.
For answers to your Monogram,® GE Profile™ or |
|
GE® appliance questions, visit our website at |
|
geappliances.com or call GE Answer Center® | Note: Use a 4'power cord to prevent |
service, 800.626.2000. | interference with unit when installing. |
| All GE ranges are equipped with |
| an |
| of this device is an important, |
| required step in the installation |
| of the range. |
Listed by Underwriters Laboratories
Specification Revised 3/12 | 220455 |