Instructions
Reversing the Door.
Safety
Installation | Instructions |
|
|
Operating | Instructions |
Care and Cleaning
Troubleshooting Tips |
Remove leveling leg and spacer and move to other side
Bottom of wine chiller
Remove right door stop and screws. Install left door stop (packed separately) and screws on other side
Remove leveling leg, screws, bottom hinge and washer, and move to other side
Remove the bottom hinge by removing the screws and leveling leg.
Remove the right door stop and install the left door stop (WR13X10274), packed separately, on the opposite side.
Remove the leveling leg and spacer on the opposite side and install it on the right side.
IMPORTANT: The left leg has a spacer that must be moved to the right side leveling leg when the door swing is reversed.
Install the bottom hinge, with the screws and leveling leg, on the left side.
Stand the wine chiller upright.
Open and close the door, checking the alignment of the door to the cabinet. If necessary, loosen the screws attaching the top hinge to the cabinet, realign the door and retighten the screws.
Place the top cover on the cabinet and reconnect the power connections.
Slide the top cover back in place and replace the two screws. 
Plug in the wine chiller. Reset the controls to the desired setting.
Consumer Support
10