GE PHP960SM installation instructions GE Profile 36 Electric Induction Cooktop, 208V 50 Amps†

PHP960SM

GE Profile™ 36" Electric Induction Cooktop

Dimensions and Installation Information (in inches)

KW Rating

240V	8.6
208V	6.5
Breaker Size
240V	50 Amps†

†Note: Check local codes for required breaker size

Important: Requires a 5" free area between the bottom of the cooktop to any combustible material, i.e., shelving. Free area not required when installing wall oven underneath cooktop. Refer to installation instructions. Requires a 15" minimum from cooktop to adjacent

36-1/821

Cooktop3-1/4*

19-1/8

13" MAX. depth

30" MIN. to unprotected cabinet

208V 50 Amps†

overhead cabinets. Units are furnished with a 36" flexible armored cable.

33-7/8

1-3/4" to rear wall

15" MIN. to cabinet

2" MIN.

clearance to

side wall

from cut-out

Note: 36" Ribbon cooktops are approved for use over GE 30" Single Wall Ovens and Warming Drawers only. Refer to cooktop and wall oven/ warming drawer installation instructions packed with product for current dimensional data. If installed with a GE Profile™ Telescopic Downdraft System, consult both the cooktop and downdraft installation instructions packed with product before installing. Cooktop gas/electric supply may need to be re-routed to install downdraft. The countertop must be at least 26" deep with a flat surface area of 23-1/2" or more, front to back. In addition, other clearances to the front edge of the countertop must be considered, especially on raised bullnose countertops. Consult cabinet and countertop manufacturer’s specs for flush mount installation prior to install.

Installation Information: Before installing, consult installation instructions packed with product for current dimensional data.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

2-1/2** Required

*Depth of unit at conduit connection location (rear) is 6-1/2" on models PP980/950 and 4-5/8" on models PHP960/PP975/972/962/945/942/932/912, JP655/356/346.

**Raised bull nose countertops may require up to 3/8" additional clearance to prevent interference with curved front.

2" MIN.

clearance to

side wall

from cut-out

Electrical junction box 16" MIN. below countertop

Cut should not interfere with cabinet structure at front

Listed by Underwriters Laboratories

Specification Revised 9/07 220578