GE ZGU36N6HSS dimensions Backsplash Accessories, Backsplash with Warming Shelf

ZGU36N6HSS (Natural Gas)

ZGU36L6HSS (Liquid Propane) – GE Monogram 36" Professional Gas Cooktop with 6 Burners

Backsplash Accessories

The cooktop requires a 12" minimum clearance to a vertical combustible surface at the rear. A backsplash is required for installations with less than 12" clearance. The following backsplash accessories are available, or a custom, non-combustible backsplash can be used.

ZX12B36HSS, 12" backsplash

ZX22B36HSS, 22" backsplash with warming shelf

Backsplash with Warming Shelf

All Monogram® Professional Hoods feature infrared warming lights. The 22"-high backsplash accessory with warming shelf is a perfect complement when installed with the tapered or straight-sided hoods.

•Restaurant-Style Professional Hoods are shipped with a stainless steel backsplash and warming shelf.

Side View with a Backsplash

9-1/2"	26-5/8"		12" Min. to Combustibles or
			0" Min. to Combustibles
3/4"
			with 12" or 22" Backsplash
	22" High	36" Min.
			36" Min.
22"		to Combustibles
	Backsplash
	with Shelf		to
12"			Combustibles
	12" High Backsplash

0" Clearance

Advance Planning for 36"

Professional Cooktops

Professional cooktops offer a number of choices in size and cooktop configurations.

•All Professional cooktops are factory set for natural or liquid propane gas. The correct model should be ordered for the installation situation.

Note: Conversion kits (WB49X10132, Nat. to LP and WB49X10133, LP to Nat.) are available if the wrong gas type was ordered. High Altitude kit, WB49X10130, is also available. The kits must be installed by a qualified service technician at additional cost.

Locate gas		2"
	7"
inlet on			16"
back wall
or on floor
2" from
back wall

Electrical Requirements

Cooktops must be supplied with 120V, 60Hz, and connected to an individual, properly grounded branch circuit protected by a 15 amp circuit breaker or time-delay fuse.

Gas Supply

•Natural gas models are designed to operate at 5" water column pressure. A regulator is required at the natural gas source to provide maximum of 7" water pressure to the cooktop regulator.

•The liquid propane models are designed to operate at 10" water column pressure. A regulator is required at the LP source to provide maximum of 14" water pressure to the cooktop regulator.

	For answers to your Monogram,® GE Profile™ or
	GE® appliance questions, visit our website at
Specification Revised 10/05	GEAppliances.com or call GE Answer Center®
	service, 800.626.2000.

130442