GE ZEU36K owner manual Using the bridge surface element, Using Tri-ring surface element

Using the bridge surface element

The surface element on the right side of your cooktop is designed to let you heat all parts of a large, oblong utensil that is too large to fit on one surface element. The Bridge Surface Element is made up of a front section, a middle section, and a rear section. You can heat all sections at once, or the front and rear sections separately.

Push down and turn the right rear surface element control knob clockwise to and select your desired setting. This will allow you to heat the right rear and middle sections of the Bridge Surface Element. To use the entire bridge element, also push down and turn the right front surface element control knob to the desired setting.

Choose pans that match the heated area as closely as possible.

To use only the right rear surface element without the middle section, push down and turn the right rear surface element control knob counter-clockwise to and select your desired setting.

Use the right front control knob to heat the right front section of the Bridge Surface Element.

Right rear surface element settings

Right rear and bridge surface element settings

Using

the tri-ring surface element

The center Tri-Ring surface element has 3 sizes to select from so you can match the size of the element to the size of the cookware you are using.

To use the large surface element, push and turn the center control knob clockwise to , stopping at the desired setting. This will activate the entire heating area.

To use the medium surface element, press and turn the center control knob clockwise to , stopping at the desired setting. This will activate the medium-size heating area.

To use the smallest surface element, press and turn the center control knob clockwise to , stopping at the desired setting. This will activate the smallest, inside heating area.

Small	Large
surface	surface
element	element
setting	setting
Medium
surface
element
setting

13