GE PP989DN, PP989SNSS dimensions For answers to your Monogram, GE Profile or, 800.626.2000

PP989SN

GE Profile™ 30" Downdraft Electric Cooktop

Dimensions and Installation Information

Installing the Ductwork: Use galvanized or aluminum duct in 6” round or 3-1/4” x 10” size, or combination of both. PVC duct or locally approved piping should be used if installing under a poured concrete slab. Local building code must be followed in specifying type and schedule of all duct used.

Note: Ductwork must be vented to outside. Do not vent into a wall, ceiling, crawlspace, attic or any concealed space. Always use an appropriate roof or wall cap with damper.

Laundry-type wall caps should never be used. For maximum efficiency use the shortest and straightest duct run possible, with as few fittings as possible.

For satisfactory performance the duct run should not exceed 100 feet equivalent length. Refer to the table of equivalent lengths (shown in installation instructions) for various duct configurations.

Through Cabinet Toe Space Between Floor Joist Inside Wall to Roof Direct to Outside

6-1/8	9-1/8
	18-3/4
10-1/8

For answers to your Monogram,® GE Profile™ or	Downward Venting	Rear Wall Venting
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,		Dimension and installation information are shown in inches.
800.626.2000.
		Listed by
		Underwriters
		Laboratories
		Specification Created 7/08

220978