GE GSM2110 Water standing, Bottom of the tub, Water won’t pump, Out of the tub, Suds in the tub

Problem	Possible Causes	What To Do
Water standing in	This is normal	• A small amount of clean
the bottom of the tub		water around the outlet on
		the tub bottom at the back
		of the tub keeps the water
		seal lubricated.
Water won’t pump	Drain is clogged	• If you have an air gap,
out of the tub		clean it.
		• Check to see if your kitchen
		sink is draining well. If not,
		you may need a plumber.
		• If the dishwasher drains
		into a disposer, run
		disposer clear.
Suds in the tub	Correct detergent	• Use only automatic
	wasn’t used	dishwasher detergents to
		avoid sudsing. Cascade®
		Automatic Dishwashing
		Detergent has been
		approved for use in all
		GE dishwashers.
		• To remove suds from the
		tub, open the dishwasher
		and let suds evaporate.
		Add 1 gallon of cold water
		to the tub. Close and latch
		the dishwasher. Pump out
		water by slowly turning the
		Dial until a drain period
		is reached. Repeat if
		necessary.
	Rinse agent	• Always wipe up rinse agent
	was spilled	spills immediately.

Safety Information

Operating Instructions

Troubleshooting Tips

Customer Service

19