GE PDW8200, PDW8500, PDW8400, PDW8600 owner manual Enhancements, Rinse only cycle

GEAppliances.com

SPEED CYCLE	Heavy 9.3 gal., 36 min.
(on some models)	Medium 7.2 gal., 36 min.
	Light 5.7 gal., 33 min.
	This cycle is for everyday dishes and glassware.
CHINA CRYSTAL	Heavy 10.0 gal., 49 min.
	Medium 7.2 gal., 36 min.
	Light 7.2 gal., 36 min.
	This cycle is for lightly soiled china and crystal.
GLASSES	Heavy 10.0 gal., 45 min.
(on some models)	Medium 7.2 gal., 33 min.
	Light 7.2 gal., 32 min.
	This cycle is specifically designed for glasses.
RINSE ONLY	Heavy 2.9 gal., 7 min.
	Light 1.4 gal., 3 min.
	For rinsing partial loads that will be washed later. Do not use detergent with this cycle.

NOTE: This dishwasher is equipped with an ExtraClean™ Sensor with automatic temperature control; therefore cycle length and time may vary depending on soil and temperature conditions.

NOTE: Only the Anti-Bacteria cycle has been designed to meet the requirements of Section 6, NSF 184 for soil removal and sanitization efficacy.

4	Enhancements
	The light above the selected pad will be ON to indicate which ENHANCEMENT has been selected.
	PRE	For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be selected
	WASH	PRIOR to starting the cycle. This option adds 16 minutes to the cycle time. NOTE: Cannot
	(on some models)	be selected with RINSE ONLY cycle.
	HEATED DRY	Shuts off the drying heat option. Dishes air dry naturally and energy is saved. For faster air dry,
	Light OFF	you can prop the door open after the CLEAN light illuminates.
	HEATED DRY	Turns the heater on for fast drying. This will extend the time to your wash cycle by 8 minutes
	Light ON	for the SPEED CYCLE and 30 minutes for all other cycles. NOTE: Cannot be selected with
		RINSE ONLY cycle.
	LOCK	You can lock the controls to prevent any selections from being made. Or you can lock the
		controls after you have started a cycle.
		Children cannot accidentally start dishwasher by touching pads with this option
		selected.
		To unlock the dishwasher controls, press and hold the HEATED DRY pad for 3 seconds. To lock
		the dishwasher, press and hold the HEATED DRY pad for 3 seconds. The light above the LOCK
		pad will turn off.
	ADDED HEAT	When selected, the cycle will run longer with heating elements on to improve both wash and
		dry performance. NOTE: Cannot be selected with RINSE ONLY cycle.
	DELAY HOURS	You can delay the start of a wash cycle for up to 9 hours (on some models). The dishwasher will
	(on some models)	count down (on some models) and start automatically at the correct time. Press the DELAY
		HOURS pad to choose the number of hours you want to delay the start of the cycle; then press
		START/RESET. The machine will count down and start automatically at the correct time.
		Pressing START/RESET a second time will cancel the DELAY START selection.
		NOTE: If you forget to fully close the door, a reminder signal will beep until you do so.
	RESET	To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle.
		The START/RESET light will flash while the water is pumped out if needed. This takes
		approximately 90 seconds. When the light stops flashing, the dishwasher can be reprogrammed
		and restarted.
		5

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support