Read these instructions completely and carefully.
Step 2—Install Warming Drawer
Safety Instructions
Slide the left corner into opening and push power cord into the hole leading to the outlet location. Thread the cord through as drawer is being pushed back into the opening.
If the outlet is installed inside the opening, plug the cord into the outlet. In this location, the excess power cord should be coiled and taped to the right side of the unit. Make sure the cord does not get trapped by the drawer.
NOTE: Insure that the power cord does not contact the hot surfaces on the bottom of ovens, cooktops, or any other appliance.
Push the drawer back until the front flange is flush to the cabinet front.
Open the drawer fully.
Drill pilot holes through the holes in the overlapping frame, one on each corner.
Drive wood screws provided into each corner.
Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support
15