Using the Warming Drawer
Electric Warming Drawer
Control knob
The warming drawer controls are hidden with the drawer shut. Open the drawer. The controls are on the right side of the front frame.
To use the warming drawer, press the ON/OFF switch to the ON position.
Slide the moisture selector control to the open or closed setting. (See the Moisture Selector section.)
Turn the control knob clockwise to the desired setting.
PROOF . . .
LOW . . . . . .
PROOF
LO
MED
HI
ON signal light
Moisture selector
The ON signal light is located below the ON/OFF switch and glows when the ON/OFF switch is in the ON position. It stays on until the ON/OFF switch is moved to the OFF position.
The moisture selector is located on the inside front of the drawer.
To keep foods moist, slide the moisture selector control away from the control knob. This closes the vent and seals the moisture inside the drawer. With the vent closed hot foods stay moist and soft.
In this setting condensation may occur around the inside edge of the drawer.
To keep foods crisp, slide the moisture selector control to the right towards the control knob. This opens the vents and allows the moisture to escape.
With the vents open, it is normal for moisture to collect on surfaces above the warming drawer.
The ON signal light is visible through the light viewer in the drawer front panel when the drawer is closed. This is a reminder that the heat is on.
Moist |
|
Closed | Crisp |
Vent | |
| Open |
| Vent |
Additional pans
An accessory pan kit JXPN1 is available from GE at extra cost.
Five commercial pans with lids (4″ deep)
•One large pan (14 quarts)
•Two medium pans (6 quarts each)
• Two small pans (3 quarts each) | 7 |