Installation instructions (all models)
Before placing food in the fresh food or freezer compartments
11
Remove all packaging. Ensure that all transit clips are removed from the refrigerator. These are small rubber stops located at the back of the shelves.
Clean the inside of the appliance with a mix of warm water, a little liquid detergent and a soft cloth to remove manufacturing and transportation dust.
Allow the refrigerator and freezer to run empty for 2 – 3 hours to allow each compartment to cool to the appropriate temperature.
The appliance may have an odour on its initial operation, but this will go when the refrigerator and freezer have cooled sufficiently.
If you have an Ice & Water refrigerator, please also carry out the following: Turn on the ice maker (refer to page 23).
At first use allow approximately a minute from when the dispensing pad is pushed until water is dispensed. This will allow the tank to fill.
Run through and discard the first 8 – 10 L of water from the dispenser, stopping intermittently (refer to page 21 – First use). Failure to do this will result in excessive dripping from your dispenser.
Discard the first bin of ice (refer to page 23 – First use).
You are now ready to enjoy ice and water from your refrigerator.
Please note that once installation is complete a few drips may appear out of the dispenser over the next few days as the remaining trapped air is cleared.
Energy efficiency
Do not cover your appliances with any material that will prevent air from flowing around the cabinet sides.
Do not leave the door open for any longer than is necessary.
Allow good clearances in front of the air ducts within the cabinet for maximum cold air distribution.