Using your warming drawer 11
To warm your crockery
1Load your crockery carefully into the drawer.
(see ‘Loading’ for suggestions on positioning of crockery)
Turn the warming drawer on
2Press the 
button to turn the warming drawer on. The halo will glow red while the drawer is on.
Select a temperature
3Select a temperature by pressing one of the temperature control buttons.
The halo will glow red while the drawer is on.
The warming drawer has three temperature settings (which are approximate depending on the load):
1 (
) = 45°C2 (
) =55°C3 (
) = 65°C
Only one temperature can be selected at a time.
If no temperature setting is selected the warming drawer will default to setting 2 (
).
Note: You may change the temperature setting during use.
Set the timer (optional)
4The warming drawer has two 
1h) and 2 hours (
2h).
To start the timer press one of the timer buttons. The halo will glow red while the timer is on.
Only one timer can be selected at a time.
At the end of the timer period the warming drawer will switch off and both the on/off and timer halos will go out.
To turn the timer off during use, press the timer button again. The drawer will continue to operate until switched off.
Note: You may turn a timer on, or change the timer selection, at any stage during use. 
If no timer is selected the warming drawer will remain on until switched off.
However, for safety reasons, after 12 hours of continuous use the warming drawer will automatically turn off.
Close the drawer
5Close the drawer fully. This ensures the most efficient heating.
Your warming drawer has a ‘soft closing’ mechanism.
When the drawer is closed, the on/off light is visible through the drawer front.
Removing warm crockery
5Crockery can be removed at any time. Please refer to the following table for suggested heating times.
Important!
Always use oven mitts to remove heated crockery from the warming drawer.