Fisher & Paykel CG604 Lighting the cooktop, Flame failure models only Hold down the knob for

Using your cooktop

19

Lighting the cooktop

1Choose the control knob for the burner you want to use.

2 Press the knob down gently and turn it anticlockwise to	1
the position. The ignitors on all the burners will
spark.
Flame failure models only: Hold down the knob for	2
approximately ten seconds after the burner has lit.
Releasing the knob too soon will extinguish the flame.

3Adjust the flame anywhere between the and positions. Do not adjust the flame between and OFF.

Note: If the burner does not light within 15 seconds, turn the control knob off and wait at least one minute before trying again.

After use, always turn the knobs to the off position. For models without flame failure, you should also close the cock valve on the gas bottle or the main gas supply line.

Flame failure safety feature (some models only)

Some cooktop models have a flame failure safety device. These models have a flame failure probe as well as the ignitor (see Fig 5).

Fig. 4a Pushing then turning the control knob (models without flame failure safety feature)

The flame failure probe cuts off the gas supply to the burner if the flame is blown out.

When lighting the burner on flame failure models, hold down the knob for approximately ten seconds after the burner has lit. Releasing the knob too soon will extinguish the flame.

Fig. 4b Pushing then turning the control knob (models with flame failure safety feature)

If the flames are accidentally extinguished, turn off the burner

and do not try to light it again for at least one minute (to allow the gas to disperse).