Sirius Satellite Radio INV2 manual Permanently install the FEA

Step 8: Permanently install the FEA

Note: If you are mounting the FEA in the vehicle’s headliner, skip this step.

When you are satisfi ed with the FEA’s mounting location, remove the suction cup mounts and peel the backing off the bead and arrow adhesive mounts. Clean the area where the FEA will be attached with the alcohol swab. Permanently adhere the FEA in the same position on the glass (or A-pillar), making certain the wire is taut and is as straight as possible (see Figure 30). If necessary, use the cable guides to hold the cable.

REMOVE	REMOVE	REMOVE
ADHESIVE BACKING	BOTH SUCTION CUPS	ADHESIVE BACKING
FROM ARROW		FROM BEAD
THIS THINNER PORTION OF THE FEA		USE THE CABLE GUIDES TO HOLD THE CABLE
SHOULD BE TAUT WHEN THE FEA		IN POSITION UNTIL IT REACHES
	IS PERMANENTLY ADHERED	THE INNER TRIM OR MOULDING

Figure 30

[ Installation ] 53