DimensionsClearances
PRODUCT DIMENSIONS
| GC600 | GC9002 | CG901M |
Width | 578mm | 914mm | 914mm |
Depth | 511mm | 533mm | 546mm |
Height | 40mm | 40mm | 76mm |
Note Height measurement below bench surface.
CUTOUT DIMENSIONS
|
| GC600 | GC9002 | CG901M |
A | Width | |||
B | Depth | |||
C | Side Clearances* | 140mm | 140mm | 118mm |
D | Rear Clearance* | 100mm | 100mm | 120mm |
E | Entry from Side | 50mm | 50mm | 25mm |
F | Entry from Back | 30mm | 30mm | 25mm |
G | Clearance Below* 60mm | 60mm | 81mm | |
| Bench |
|
|
|
*Minimum clearance for cutout to combustible surface.
When used with a flexible hose, the connector on the wall should be between 800mm to 850mm above the floor and in the region outside the width of the appliance to a distance of 250mm. This should be accessable with the appliance installed.
RANGEHOOD CLEARANCE (Dimension A)
[See A.G.A. 601 5.12.1.6]
Dimension A (Measured from the plane of the pan supports to Rangehood) should not be less than 650mm.
Any other downward facing combustible surface less than 600mm above the highest part of the hob
shall be protected for the full width and depth of the cooking surface area.
However, in no case should this clearance to any surface be less than 450mm.
SIDE CLEARANCE (Dimensions B & C)
Where Dimension B, measured from the periphery of the nearest burner to any vertical combustible surface, is less than 200mm, the surface shall be protected in accordance with Clause 5.12.1.2 to a Height C of not less than 150mm above the hob for the full dimension (width or depth) of the cooking surface area.
Do use
A.G.A. Clause 5.12.1.2.
A.G.A. Clause 5.12.1.2. Protection of a Combustible Surface Near a Cooking Appliance.
The protection required by clause 5.12.1.1. shall ensure the surface temperature of the combustible surface does not exceed 50°C above ambient.
Note The fixing of 5mm thick ceramic tiles to the surface or attaching fire resistant materials to the surface and covering with sheet metal with a minimum thickness of 1.4mm would satisfy this requirement.
CLAMPING DOWN THE COOKTOP/HOB
Place the cooktop into the cutout and tighten it with the supplied clamps. DO NOT OVER TIGHTEN.
The clamps will cope with bench thickness