Fisher & Paykel CG755 installation instructions Cleaning chart

Care and cleaning

27

Cleaning chart

What? Soiling examples How? Important!

Stainless	fingerprints	1	Wipe with a clean
steel strip	food stains	2	damp cloth.
			Dry with a soft, lint-
			free cloth.

Regular use of a stainless steel polish will reduce fingerprints and other marks Follow the manufacturer’s instructions.

Never use harsh/abrasive cleaning agents and scourers as they will damage the stainless steel finish. Chlorine compounds in some cleaners (eg bleaches) are corrosive to stainless steel and may damage its appearance. The graphics are etched onto the steel by laser and will not rub off.

Knobs	fingerprints	1	Clean with hot
	food stains	2	soapy water.
			Dry thoroughly with
			a soft cloth.
Glass	dust	1	Remove the pan	Remove stains left by sugary
surface	stains left by liquid		supports, burner	food or spillovers as soon as
	spillovers or burnt-		caps, and flame	possible. If left to burn on or
	on food	2	spreaders.	cool, they may be difficult to
	sugar, sugary syrups,		Remove any spills or	remove or even permanently
	jams and jellies	3	burnt-on food.	damage the glass surface.
	vegetables and		Apply ceramic glass	Take extreme care when
	vegetable water with	4	cooktop cleaner.	working around hot surfaces!
	a high sugar content		Wipe with a clean,	Heavy-duty scourers, some
	eg peas, sweet corn,		damp cloth and dry.	nylon scourers and harsh/
	beetroot			abrasive cleaning agents
				may scratch the glass. Always
				read the label to check if your
				cleaner or scourer is suitable.

Pan	stains left by liquid	1	Remove parts, then
supports,	spillovers or burnt-on		soak to remove
burner caps	food		stubborn stains,
and ring			then wash with hot
		2	soapy water.
			Rinse, then dry with
			a soft cloth.
Flame	soiling trapped in	1	Use a stiff nylon
spreaders	the holes and		brush or a
	notches		straightended paper
			clip to clear the
			holes and notches.
		2 Wash with hot soapy
		3	water.
			Rinse and wipe dry.

Make sure you replace the burner parts correctly, as shown in the drawings following.

Do not use the burners without all its parts correctly in place.

Dry all burner parts thoroughly before replacing as even small droplets

of water will affect the performance of a burner.

Ignitor	food or liquid spillovers	Use a toothbrush	A dirty or wet ignitor will prevent
	on these parts	and methylated spirits	the burner from lighting
		to clean these. See	efficiently.
		Fig. 15.
Flame			A dirty probe may prevent the
failure			flame failure device from
probe			working effectively.