TechniSat VC 2002 S manual Programming, Watching a scrambled Videocrypt programme, Screen Messages

Page 8

TechniSat® VC 2002 S

PROGRAMMING

Watching a scrambled Videocrypt programme

1.Select a coded channel (eg. Movie Channel or Sky Movies Plus).

2.Insert the viewing card as indicated by the arrow.

3.After a few seconds the descrambled picture will appear on the screen.

NOTE: Do not bend or damage the card in any way.

SCREEN MESSAGES:

Please insert card” - make sure that the card is inserted correctly.

Please wait” - descrambled picture should appear in a few seconds.

Your card is invalid” - ensure the card is ins- erted correctly and/or has not been damaged. “Your card has expired” - a replacement card is required.

Channel blocked” - indicates there is some- thing wrong with your card.

In the case of the last 3 messages, first of all try turning the receiver off, disconnect from the mains and leave for one minute. Turn on again and retry card. If this still fails contact BSkyB.

CONNECTING A SEPARATE DECODER: (*)

To choose between normal and decoder mode press DECODER:

In position “n” the reception signal will be connec- ted directly from the TV or video recorder.

In position “d” the coded signal (non-Videocrypt coded channels) is sent from the scart socket to the decoder. The decoded signal is sent back to the receiver and can be picked up at the scart socket or at the UHF output connection.

Press the D MODE button to select the deco- der signal according to the following table:

D1: Flat, MAC compatible signal

D2: PAL de-emphasised baseband signal

D3: Unclamped video signal

D4: Clamped video signal

Be sure to consider the recommendation of the manufacturer regarding the connection of the decoder.

(*)DOES NOT APPLY TO VIDEOCRYPT INTER- NAL DECODER, BUT REFERS TO THE USE OF A SEPARATE DECODER FOR NON- VIDEOCRYPT CODED CHANNELS.

FREQUENCY SHIFT:

If the LNB of the outdoor unit does not supply the exact IF-frequency, it is possible to change it as follows:

1.Press the “V/H” button for about 3 seconds.

2.The receiver displays “AFC”.

3.Enter “999”.

4.The receiver displays “0.0”.

5.Now it can be tuned up or down (+/- 5 MHz) with the tuning buttons.

6.Once you have achieved the best picture quality you can store the frequency shift with the STORE button.

NOTE: The frequency shift applies for all channels.

8

Image 8
Contents VC 2002 S Care and USE Safety InstructionsInstallation Contents Back Panel Appliance DescriptionFront Panel Installation & Initial Operation Remote ControlInstallation possibilities Individual Programming Audio TuningPreprogramming Connecting a Separate Decoder ProgrammingWatching a scrambled Videocrypt programme Screen MessagesSpecifications TunerTrouble Shooting Problem CAUSE/SOLUTIONLevel Video Mode Sation Programme V/H-LNBVideo Mode Programme ISISAT-LNB