CONTROL PANEL
MODELS: HNI, HTNI ELECTRONIC TOUCH CONTROLS
A. Motor OFF button
B.ON button and motor speed selection button 1, 2, 3, 1,....
C.Speed 1LED
D.Speed 2 LED
E.Speed 3 LED
F.Timer LED
G.Timer.
If the motor is off while the timer is pressed the motor will run at speed 3 for 20 minutes then stop.
If the motor is running when the timer key is pressed the motor will continue to run for 10 minutes. After 10 minutes the motor will stop.
Pressing the timer or speed button while the Timer LED is on will disable the timed mode.
H.Light ON/OFF button.
I.Dim Light ON/OFF button (only for model HTNI).
Fig. 1
Circuit
The control allows the user to perform a
The self test is activated by pressing the A and B keys simultaneously for 3 seconds.
The
1.Four LED’s switch on.
2.Four LED’s switch off.
3.Blower runs at speed 1.
4.Blower runs at speed 2.
5.Blower runs at speed 3.
6.Blower off.
7.Lights switch on.
8.Lights dim (only for model HTNI).
9.Lights turn off.
10.Beep signals end of
OPERATING INSTRUCTIONS - HOOD
The blower should be turned on for 10 minutes before cooking in order to establish air currents through the
Grease Filter Saturation LED
The speed 2 LED in Figure 1 in is marked with an F. This LED will flash to remind you when the grease filter needs to be cleaned after 40 hours use. Follow the instructions for cleaning filters in thisFollow the instructions for cleaning filters in this booklet. Once the grease filters have been cleaned, reset the display by pressing button A for 3 seconds until you hear the signal (beep).
hood. This will improve the capture and removal of heat, smoke, moisture, grease and cooking odors. Use the low speeds for normal use and the higher speeds for strong odors or fumes.
Drafts across the range or cooktop will reduce the effectiveness of the hood. Such drafts should be pre- vented when possible.
Page 4