Allstar Products Group 9921TK, 9931T PUT the Transmitter in Program Mode, Enter Your 9 Digit Code

NOTE: The table has a row for each one of the three buttons since it is possible to set a unique code for each

button. Write the code that you matched from your transmitter or receiver in the grids below.

1 2 3 4 5 6 7 8 9

+/ On

BUTTON

Zero

BUTTON

-/ Off

BUTTON

- PUT THE TRANSMITTER IN PROGRAM MODE -

INSTRUCTIONS FOR USE WITH AN ALLSTAR

SMART RECEIVER

When using the Allstar Classic with a Smart Receiver there is no need to

match a switch setting.

Simply make up your own unique code, enter it in the grid on page 2

1. First, press and hold the + button. The Red LED will turn on. Next, while continuing to hold the + button,

press and hold the - button. Continue to hold both buttons until the LED starts to blink (approximately 5 seconds). Release both buttons while the LED is blinking. The LED will blink two times and then remain on to confirm you are in programming mode. Go to Step 2

1a. First, press and hold the - button. The Red LED will turn on. Next, while continuing to hold the - button,

press and hold the + button. Continue to hold both buttons until the LED starts to blink (approximately 5 seconds). Release both buttons while the LED is blinking. The LED will blink two times and then remain on to confirm you are in programming mode. Go to Step 2

and follow the instructions starting with Step 1.

When the transmitter is programmed, follow the instructions for teaching

the receiver the transmitter code.

Note: If you want to program all the buttons you can Express Code them by selecting the + button in Step 2 and ending the 9 position code in Step 3 with a +. This will code all three buttons in one programming step.

*If the LED goes out, start over.

*If the LED goes out, start over.

IMPORTANT

WARNING

Keep transmitters and remote controls

-SELECT THE BUTTON YOU WISH TO USE

2.While the LED is on, press the button you wish to use. (If your block has 8

switches press the + button, if not, press any button you’d like to use). The LED will blink off once and

then remain on. Go to Step 3...

The SAME CODE must be set on both the transmitter and receiver. The controls will not function if the codes are mismatched.

out of the reach of children.

Do not let children play with or use the

transmitter or remote controls. Unexpected door operations can cause personal injury or property damage.

Do not place transmitter where the buttons

can be accidentally or unintentionally

activated.

-ENTER YOUR 9 DIGIT CODE

3.Enter the 9-digit code from the table pressing the buttons that correspond with the grid above. (If your block has 8 switches

use the + button in the 9th position) Go to Step 4...

4. After the 9-digit code is entered, the LED will blink twice to confirm a valid code and remain off.

Installing the Transmitter

The transmitter is supplied with a metal clip which may be used to attach the unit to a sun visor. If the clip is used, slide it into the recess provided on the back of the transmitter

case until the snaps on the case fit around the clip. If the transmitter is installed in a pocket in your car, follow all the manufacturer’s instructions.

Battery Replacement

The MVP Quik-Code transmitter is provided with two factory installed 3-volt batteries which should be replaced after two years of normal use. The transmitter code is retained in permanent memory and will not be lost during battery replacement. To replace the batteries, remove the back of the case with a small screwdriver. Carefully slip the batteries out of the holders and replace with fresh CR2032 3-volt batteries. The “+” on the batteries must point away from the circuit board. Replace the back of the cover and resume normal use.

5.Repeat the procedure for the remaining buttons.

Improper transmitter installation or use may cause intermittent operation which can

result in unexpected door operations.