GE HSS25, GSS22, GSS20, GSS25, ESS25, ESS22, HSS22, SSS25 manual Installation, Remove and Discard

Page 5

Installation

ATTENTION INSTALLER:FOR A QUALITY INSTALLATION, FOLLOW THESE INSTRUCTIONS.

ROLLERS

HEX-HEAD BOLTS (4)

• REMOVE AND DISCARD

SKIDBOARDS and bolts used to

hold skidboards.

CARDBOARD

PROTECTS

DOOR EDGES

MAKE SURE FRONT

ROLLERS DO NOT

REST ON TRUCK

RAISE

DO NOT

OVER-

TIGHTEN

STRAP

ROLLER

ADJUSTMENT

TRUCK FROM

SIDE ONLY

•ADJUST FRONT ROLLERS

so that refrigerator is solid and doors close easily.

9 IS COLDEST

0 IS OFF

4

5

6

4

5

6

3

 

7

3

 

7

2

 

8

2

 

8

 

 

 

 

1

 

9

1

 

9

0

 

 

 

 

 

FREEZER

FRESH FOOD

•SET BOTH CONTROLS TO “5”.

•SET ICEMAKER TO OFF until

water line is connected.

• Use PADDED HAND TRUCK

to protect refrigerator finish.

• LEAVE TAPE ON DOORS until

• MAKE SURE DOORS ARE EVEN

refrigerator is in its final location.

AT TOP. Check gasket seal.

•IMPORTANT: IMMEDIATELY REMOVE ALL CLEAR PROTECTIVE TAPE FROM TRIM.

•TO REMOVE TAPE RESIDUE AND HANDPRINTS, USE APPLIANCE POLISH.

•REMOVE ALL TAPE AND OTHER PACKAGING MATERIAL FROM INSIDE REFRIGERATOR. DO NOT REMOVE SERIAL PLATE.

IF NECESSARY TO REMOVE DOORS, REMOVE ALL HINGES. FOR DISPENSER MODELS:

TO REINSTALL DOORS...

TUBING CLIP

COLLAR

PRESS THE WHITE COLLAR AS YOU PULL OUT THE TUBING.

WHEN INSTALLING DOORS...

5⁄8″ – 3⁄4″

• Push tubing into connector

(5⁄8″ to 3⁄4″ ) to prevent leakage.

HINGE COVER

WIRING CONNECTORS

ALIGN DOORS EVENLY

FRESH FOOD HINGE

AT TOP

ADJUSTMENT PIN

•

Reinstall lower hinges and tighten hinge screws firmly.

• Place door on lower hinge pin and install upper hinges.

 

Tighten upper hinge screws firmly.

•

Align both doors evenly at top by adjusting pin on lower

 

fresh food hinge.

•

At lower left hinge, remove tubing

•

At upper hinges, disconnect wiring connectors.

 

from the clip.

•

Remove both hinges with each door to prevent

 

 

•

Disconnect the water line.

 

damage to tubing or wiring.

• Reconnect wiring connectors and reinstall hinge covers.

•

Reinstall tubing by pushing tubing into connector.

•

Put tubing back into clip.

FRANÇAIS • ESPANOL

PREFERRED

METHOD

MAKE SURE PROPER

GROUND EXISTS

BEFORE USE

TEMPORARY METHOD (Adapter plugs not permitted in Canada)

ENSURE PROPER

GROUND AND

FIRM CONNECTION

BEFORE USE

IMPORTANT: PLEASE READ CAREFULLY

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

The power cord of this appliance is equipped with a three-prong (grounding) plug that mates with a standard three-prong (grounding) wall receptacle to minimize the risk of electric shock hazard from this appliance. The customer should have the wall receptacle and circuit checked by a qualified electrician to make sure the receptacle is properly grounded.

Where a standard two-prong wall receptacle is encountered, it is the personal responsibility and obligation of the customer to have it replaced with a properly grounded three-prong wall receptacle.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD.

USAGE SITUATIONS WHERE THE APPLIANCE’S POWER CORD WILL BE DISCONNECTED INFREQUENTLY

Because of potential safety hazards under certain conditions, we strongly recommend against the use of an adapter plug. However, if you still elect to use an adapter, where local codes permit, a TEMPORARY CONNECTION may be made to a properly grounded two-prong wall receptacle by the use of a UL listed adapter which is available at most hardware stores. The larger slot of the adapter must be aligned to provide proper polarity in the connection of the power cord.

CAUTION: Attaching the adapter ground terminal to the wall receptacle cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wall receptacle is grounded through the house wiring. The customer should have the circuit checked by a qualified electrician to make sure the receptacle is properly grounded. When disconnecting the power cord from the adapter, always hold the adapter with one hand. If this is not done, the adapter ground terminal is very likely to break with repeated use. Should this happen, DO NOT USE the appliance until a proper ground has again been established.

USAGE SITUATIONS WHERE THE APPLIANCE’S POWER CORD WILL BE DISCONNECTED FREQUENTLY

Do not use an adapter plug in these situations because frequent disconnecting of the power cord places undue strain on the adapter and leads to eventual failure of the adapter ground terminal. The customer should have the two-prong wall receptacle replaced with a three-prong (grounding) receptacle by a qualified electrician before using the appliance.

197D3266P001 31-5087 9-00 JR

– 3 –

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Technical Service Guide Important Safety Notice Table of Contents Introduction Remove and Discard InstallationSpecifications Nomenclature S 2 5 I F M a F W WFor The Period GE Will Replace One Year Warranty InformationTable of Contents Operating CharacteristicsCooling Operation Adaptive Defrost Abnormal Operating Characteristics Incorrect OperationAdaptive Defrost Pre-Chill Operation Adaptive DefrostDefrost Heater Operation Adaptive Defrost Liner Protection ModeDwell Period Adaptive Defrost Post Dwell Adaptive DefrostFilters Dispenser Lock Hinge System and Door ClosureJelly Roll Condenser Airflow Cabinet InteriorInputs Main Control BoardGeneral Locator Views Capacitor Mechanical Disassembly Page Door Handles Door GasketDoors and Door Hinges Door RemovalControl Panel Fresh Food Door AdjustmentWater Filter Cartridge Fresh Food LightDrawers and Bins ShelvesDoor Shelf Extenders Freezer LightIcemaker Evaporator Fan Ice Dispenser DriveDefrost Heater and Freezer Thermistor Connectors ScrewsDoor Dispenser Target Switch Overtemperature Thermostat and Evaporator ThermistorDoor Dispenser Control Panel Fresh Food ThermistorIce Dispenser Drive Motor Ice CrusherIce Cube Solenoid EvaporatorDispenser Heater Condenser FanWater Solenoid Roller AssemblyFresh Food Air Damper Cable ConnectorPage Page Efficient Use of Diagnostics DiagnosticsAbove Failure Causes Freezer Compartment Fresh Food CompartmentCycle Normal BelowProcessing Unit Unit Main Control Board 120 VAC SideVDC Page When activated Basic refrigerator checks Fresh Food Warm Freezer WarmFreezer Warm Fresh Food Normal Check control settings and temperaturesBasic refrigerator checks Fresh Food Warm Freezer NormalFresh Food Too Cold Freezer Normal Reset electronics by unplugging Refrigerator for 15 secondsRefrigerator Dead, No Sound, No Cooling Fan motor Evaporator Fan Not RunningReplace main control board Control board, make certain to Condenser Fan Not RunningDamper Door Not Operating Compressor Not Running Heavy Frost on Evaporator Thermistor Values Temperature Resistance in Kilo Degrees C Degrees F OhmsComponent and Connector Locator Views Fresh Food Thermistor Lights Capacitor Door Freezer Door SchematicsPage REV H and higher Page Illustrated Parts Catalog Page Page Page Page Page Page Page Page

SSS25, HSS22, HSS25, ESS22, ESS25 specifications

General Electric (GE) has consistently been at the forefront of innovative technologies and solutions for various industries. Among its notable offerings are the GE GSS22, GSS20, GSS25, ESS25, and ESS22 models which reflect the company's commitment to efficient design and functionality in energy systems and appliances.

Starting with the GE GSS22, this model is designed with a focus on energy efficiency and modern convenience. It features advanced adaptive cooling technologies that optimize temperature control, ensuring food stays fresh longer. The stainless-steel finish not only provides a sleek look but also offers durability and ease of cleaning. Additionally, the GSS22 comes equipped with adjustable shelves and ample storage options, making it incredibly versatile.

The GSS20 model takes similar features and enhances user experience with its user-friendly interface and additional storage solutions. It incorporates a unique filtration system that keeps ice and water clean and fresh, and its state-of-the-art LED lighting illuminates the interior efficiently. The GSS20 is designed to meet the needs of families, with ample space for groceries and easy organization.

For those requiring greater capacity and advanced features, the GE GSS25 is an optimal choice. It boasts a large capacity and includes specialized compartments that cater to different food types. The internal cooling technology evenly distributes cool air, preventing temperature fluctuations. This model also features smart connectivity options that allow users to monitor and adjust settings remotely via a smartphone app, reflecting the trend towards smart appliances.

The ESS25, part of GE's energy-efficient series, emphasizes sustainability without sacrificing performance. It utilizes eco-friendly refrigerants and incorporates design techniques that minimize energy consumption. The ESS25 features an intuitive control panel and practical storage configurations to maximize efficiency in space usage.

Lastly, the GE ESS22 model is tailored for those looking for a balance between size and efficiency. This model emphasizes energy savings while still delivering full functionality. With smart features like temperature control alarms and adjustable humidity settings, ESS22 focuses on preserving the quality of food stored inside.

Overall, the GE GSS and ESS series stand out in the market due to their blend of innovation, energy efficiency, and user-centered design, making them suitable options for modern households looking to enhance their kitchen experience.
Top Page Image Contents