GE GBC12 owner manual Remove the Freezer Door

Installation Instructions

REVERSING THE DOOR SWING (CONT.)

3REMOVE THE FREEZER DOOR

ATape the door shut with masking tape.

BRemove the center hinge and shim(s) by removing the screws. Be sure to keep the shim(s).

CRemove the tape and lift the door off the bottom hinge pin.

DSet the door on a non-scratching surface.

CAUTION: Do not let door drop to the floor.

4INSTALLING THE DOOR STOPS

AWith the doors laying on a non-scratching surface, remove the door stop from the bottom of each door using a Phillips screw driver.

BRetrieve new door stops from the accessory bag.

CInstall new door stop on the opposite side of each door by fully inserting the pin into the hole in the door. You may have to clear the hole of insulation foam using a screw driver. Secure each door stop in place with the screw provided.

5TRANSFER BOTTOM HINGE TO THE LEFT

ARemove the bottom hinge bolts with a 5/16" socket driver. Discard the hinge to the accessory bag, saving the shim(s).

BUsing a flat blade screw driver, remove the bottom hinge hole covers from the left side and transfer to the right side.

CRetrieve a new bottom hinge from the accessory bag and install the new hinge and shim(s) on the left side. Do not tighten the bolts completely.

6REHANG THE FREEZER DOOR

APlace the freezer door on the bottom hinge, close the door, MAKE SURE IT IS ALIGNED PROPERLY, and tape it in place with masking tape.

BTighten the bottom hinge bolts completely, ensuring that the door is level and aligned properly.

10