Before Removing the Doors
Unplug the refrigerator from its electrical | CAUTION: Do not let either door drop to the floor. To do so |
outlet. | could damage the door stop. |
Empty all door shelves, including the dairy |
|
compartment. |
|
Remove the Refrigerator Door
Remove the top hinge cover (lift up on the outside edge and pull off).
Tape the door shut with masking tape at both upper corners.
With 5/16″ hex socket driver, remove the
3 screws that hold the top hinge to the cabinet.
Lift the hinge straight up to free the hinge pin from the socket in the top of the door. Carefully peel off the adhesive backed spacer from the top of the cabinet.
Remove the tape, tilt the door away from the cabinet and lift it to free its bottom socket from the hinge pin on the center hinge bracket.
Set the door on a
Safety Instructions Operating Instructions Installation
To Reverse the Refrigerator Door— Transfer Center Hinge Bracket to the Left
Open the freezer drawer and remove the hinge bracket from the center right side of the cabinet by removing the three Phillips head screws.
Remove the three outermost 5/16″ hex head screws from the center left side of the cabinet and insert them into the holes just vacated by the Phillips head screws on the center right side.
Remove the center hinge pin from the hinge bracket using a 5/16″ hex socket driver. Invert the hinge bracket with shim and reinstall hinge pin in hinge bracket. Secure this assembly with the three Phillips head screws removed from the right side. Tighten all screws.
NOTE: If the washer is not on the hinge pin, check to see if it is stuck to the bottom of the door.
Center Right
Center Hinge Pin
Plastic Washer
Center Left
Center Hinge Pin
Plastic Washer
Instructions Troubleshooting Tips Consumer Support
13