Philips MC M570 manual Programming the disc tracks, G l i s h, Checking the programme

Disc Operations

E n g l i s h

Programming the disc tracks

Programming tracks is possible when playback is stopped. Up to 99 tracks can be stored in the memory in any order.

IMPORTANT!

It is only possible to programme from the current selected disc tray.

2

	1					4
						6
			P L AY
DISC 1	DISC 2	3	DISC 4	DISC 5
					OPEN/
					CLOSE	7
DISC 21					1
DISC 32					23
DISC 43
DISC DISC1 54					3
DISC 5					4
						3 ,	5
			CD / CD-R / CD-RW COMPATIBLE		5

Notes:

–If the total playing time reached 100 minutes or if one of the programmed tracks has a number greater than 30, then "--:--" is displayed instead of the total playing time.

–The system will exit programming mode if no button is pressed within 20 seconds.

Checking the programme

1Stop playback and press í or ë repeatedly.

2Press Ç to exit.

OR

Press ÉÅto start playback from the current programmed track

Clearing the programme

●Stop playback, then press Ç to clear the programme.

OR

1Load the desired discs on the disc trays (refer to “Loading discs”).

2Press CD or one of the DISC 1~5 buttons to select a disc.

3Press PROGRAM (PROG) to start programming.

➜ PROG starts flashing.

4Press í or ë repeatedly to select the desired track.

●For MP3 disc, press à / á (ALBUM 43) and í / ë (TITLE -+) to select the desired album and title for programming.

5Press PROGRAM (PROG) to store.

●Repeat steps 4–5to select other tracks.

➜ If you attempt to programme more than 99 tracks, "PROGRAM FULL" is displayed.

6To start programme play, press ÉÅ.

7To stop playback or to end the programming, press Ç once.

➜ PROG stays and the programme mode remains active.

Press the OPEN/CLOSE 0 button of the disc tray.

➜PROG disappears and "PROGRAM CLEARED" is displayed.

Note:

–The programme will be erased if the system is disconnected from the power supply or you switch to other source mode.

18