Getting Started
English
Step 1: Using Remote Control
IMPORTANT!
–Before using the remote control, remove the insulation plastic tab as shown in the picture below.
–If the remote control does not function correctly or the operating range is reduced, replace the battery with a new (CR2025) battery.
1Push to open the battery tray.
2Replace a new battery according to the indicated polarity.
3Push the battery tray back to close it.
Using the Remote Control to operate
the Player
1Aim the Remote Control directly at the remote sensor (IR) on the front panel.
Step 2: Setting up the TV
IMPORTANT!
Make sure you have completed all the necessary connections. (See “Connecting TV”).
1Switch the DVD system on and then select DISC source. (See ÒSwitching the system on/offÓ).
2Turn on the TV and set to the correct
➜Usually these channels are between the lowest and highest channels and may be called FRONT, A/V IN, or VIDEO. See your TV manual for more details.
➜Or, you may go to channel 1 on your TV, then press the Channel up button repeatedly until you see the Video In channel.
➜Or, the TV Remote Control may have a button or switch that chooses different video modes.
➜Or, set the TV to channel 3 or 4 if you are using an RF modulator.
Selecting the color system that matches
your TV set
This DVD system is compatible with both NTSC and PAL. For the playback of a DVD disc on this DVD system, the color systems of the DVD,TV set and DVD System should match.
MODE | CLOCK SLEEP/TIMER |
2Select the source you wish to control by pressing one of the source select buttons on the remote.
3Then select the desired
function (for example, ÉÅ, ¡ or ™).
OK
+
4
TV DISPLAY |
|
TV TYPE | MULTI |
SCREEN SAVER |
|
CAUTION!
–Remove the battery if it is exhausted or if the Remote Control is not being used for a long time.
–Batteries contain chemical substances, so they should be disposed of properly.
SET TO MULTI |
18