E |
| Tuning to radio stations |
ngli |
| |
1 | Press POWER to switch on the last selected source. | |
sh | 2 | Adjust SOURCE (or press TUNER on the remote |
| ||
|
| control) to select the desired band : FM or AM. |
|
| ➜ If an FM station is received in stereo, “STEREO” icon |
|
| appears. |
| 3 | If necessary, press TUNING•PRESET to switch on tuning |
|
| mode. |
| 4 | Press and hold S or T until the frequency indication |
|
| starts to change, then release. |
|
| ➜ The system automatically tunes to the next strong radio |
|
| station. |
| ● | To tune to a weak station, press S or T briefly and |
|
| repeatedly until optimal reception is found. |
| 5 | Repeat step 4 if necessary until you find the desired radio |
|
| station. |
Presetting radio stations
You can preset up to 30 AM and 30 FM stations regardless of the reception.Tune in the desired stations using automatic or manual tuning.
Manual Preset
1Tune to your desired radio station (refer to “Tuning to radio stations”).
2Press PROGRAM.
➜“PROG” icon starts flashing.
➜The next available preset number is displayed for selection.
To store the radio station to another preset number
●While “PROG” icon is flashing, press S or T( 1 / 2 on the remote control) to select the desired preset number.
Note:
–If “PROG” icon goes off before you select the desired preset number, press PROGRAM again.
3Press PROGRAM again to store the radio station. ➜ “PROG” icon stops flashing.
●Repeat steps
22
Automatic Preset
1Adjust SOURCE (or TUNER on the remote control) again to select the desired band : FM or AM.
To begin automatic preset from a desired preset number
●Press TUNING•PRESET to switch on preset mode and followed by S or T ( 1 / 2on the remote control) to select the desired preset number.
2Hold down PROGRAM until the “PRESET” icon flashes.
➜All available radio stations with sufficient signal strength will be stored automatically.
➜It will stop automatically when all the available radio stations are stored or the memory for 30 presets is used.
●To store stations on the other band, repeat steps
To stop storing the automatic preset
●Press PROGRAM again. Notes:
–If no preset number is selected, automatic preset will begin from preset (1) and all your former presets will be overridden.
–During programming, if no key is pressed within five seconds, the system will exit the program mode automatically.
Listening to preset radio stations
●In tuner mode, press TUNING•PRESET to switch on preset mode and followed by S or T ( 1 / 2 or numeric keypad
➜ The preset number, radio frequency, and waveband are displayed.
RADIO RECEPTION