Philips MCM5 user manual Basic Operations, Switching on/off, Demonstration mode, Setting the clock

Basic Operations

English

Switching on/off

Switching to an active mode

●Press CD, TUNER, TAPE or AUX.

Switching to Eco Power standby mode

●Press B.

➜ECO POWER button lights up.

➜The display screen will go blank.

Switching to standby mode (view clock)

●Press and hold B.

➜The clock appears.

➜While in standby mode, pressing CLOCK button will switch the system to Eco Power standby mode.

Helpful Hint:

–Before switching the system to Eco Power standby or standby mode, make sure you have deactivated the the demonstration mode.

Demonstration mode

If the demonstration mode is active, whenever you switch the system to Eco Power standby or standby mode, it will begin showing the various features offered by the system.

To activate the demonstration

●In Eco Power standby/standby mode, press and hold Ç on the main unit until "DEMO ON" appears.

To deactivate the demonstration

●Press and hold Ç on the main unit until "DEMO OFF" appears.

Setting the clock

The clock can be set in either 12-hour or 24-hour mode ("11:59 PM" or "23:59" for example).

PROGRAM	(00:00 î 12:00AM)
2

(00:00 / 12:00AM)

4 (00:00 / 12:00AM)

3 , 4

CLOCK

1 , 5

1Press and hold CLOCK until the clock time starts flashing.

2Press PROGRAM repeatedly to change between 12-hour and 24-hour clock mode.

3Press à or á repeatedly to set the hour.

4Press ÉÅ to change to minutes setting, then press à or á repeatedly to set the minutes.

5Press CLOCK again to store the setting.

➜ The clock will start working.

To view the clock time in any active mode

●Press CLOCK once.

➜ The clock is displayed for a few seconds.

Helpful Hints:

–The clock setting will be erased when the system is disconnected from the power supply.

–The system will exit clock setting mode if no button is pressed within 90 seconds.

–To set the clock automatically through the time information in the RDS signal, refer to "Tuner Operations – Setting the RDS clock".

12