Before contacting After Sales Service:
1.See if you can solve the problem yourself (see “Troubleshooting guide”).
2.Switch the appliance on again to see if the problem has been solved. If it has not, disconnect the appliance from the power supply and wait for about an hour before switching on again.
3.If the problem persists after this course of action, contact
Specify:
•the nature of the fault,
•the model,
•the service number (the number after the word SERVICE on the rating plate on the rear of the appliance),
•your full address,
•your telephone number and area code.
Note:
The direction of door opening can be changed. If this operation is performed by
INSTALLATION
&Install the freezer away from heat sources.
Installation in a hot environment, direct exposure to the sun or installation near heat sources (heaters, radiators, cookers) will increase power consumption and should therefore be avoided.
If this is not possible, the following minimum distances must be respected:
30 cm from coal or paraffin stoves
3 cm from electric stoves.
•Install the appliance in a dry,
•Clean the interior (How to defrost and clean the appliancesee.
•Fit the accessories.
•Check the door seal is not damaged or deformed, especially after installation or reversal of door opening.
Electrical connection
•Ensure that the voltage indicated on the appliance rating plate corresponds to the domestic supply voltage.
•Regulations require that the appliance is earthed. The Manufacturer declines all liabilities for injury to persons or animals or damage to proper resulting ty from failure to
observe these regulations.
• If the plug and socket are not of the same type, have the& socket replaced by a qualified electrician.
• Do not use extension cables, multiple sockets or adapters.