CDA FW850 manual Electrical connection, Disconnecting the appliance

AFTER-SALES SERVICE

Before calling After-sales Service:

1.See if you can solve the problem yourself with the help of the Troubleshooting Guide.

2.Switch the appliance on again to see if the problem persists. If it does, switch off and wait for about an hour before switching on.

3.If the problem persists after this action, contact After-sales Service.

Specify:

•the nature of the fault,

•the model,

•the service number (the number after the word SERVICE on the rating plate on the inside of the appliance),

•your full address,

•your telephone number and area code.

Note:

The direction of door opening can be changed. If this operation is performed by After-sales Service it is not covered by the warranty.

INSTALLATION

•Install the appliance away from heat sources. Installation in a hot environment, direct exposure to the sun or installation near heat sources (heaters, radiators, cookers) will increase power consumption and should therefore be avoided.

•If this is not possible, the following minimum distances must be respected:

•30 cm from coal or paraffin stoves;

•3 cm from electric or gas cookers.

•Install the appliance in a dry, well-ventilated place.

•Clean the interior (see the relative heading in this handbook).

•Fit the accessories.

Electrical connection

•Electrical connections must be made in accordance with local regulations.

•Voltage and power consumption are indicated on the rating plate inside the appliance.

•The appliance must be earthed by law. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the above prescriptions.

•If the plug and socket are not of the same type, have the socket replaced by a qualified electrician.

•Do not use extension leads or adaptors.

Disconnecting the appliance

It must be possible to disconnect the appliance by unplugging it or by means of a two-pole switch fitted upline of the socket.