Clock/Timer
Setting the clock
There are two possible methods for setting the clock: manually or automatically by using RDS.
Automatic clock setting (RDS versions
only)
1Tune to a RDS station (see “Radio Reception”).
2Press CLOCK SET for more than 2 seconds.
➜SEARCH RDS TIME is displayed for a maximum of 90 seconds; the time is then displayed.
➜NO RDS TIME is displayed if no time signal has been received and you will have to set the clock manually.
Manual clock setting
1In standby, press CLOCK SET.
➜The clock digits for the hours flash.
2Turn VOLUME to set the hours: clockwise for hours up;
3Press CLOCK SET again.
➜The clock digits for the minutes flash.
4Turn VOLUME to set the minutes: clockwise for minutes up;
5Press CLOCK SET toº confirm the time.
Note:
– The backlight for clock display is dim in standby.
Setting the timer
●The system can be used as an alarm clock, whereby the CD,TUNER or TAPE is switched on at a set time.The clock time needs to be set first before the timer can be used.
●You can also use it to record a favourite tuner programme at a set period (see “Recording timer”)
●During setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically.
1In any mode, press TIMER ON•OFF for more than 2 seconds.
2Turn VOLUME clockwise to select sound source.
➜ Display sequence shows CD, TUNER, TAPE or
REC TUNER.
3Press TIMER ON•OFF to confirm your
desired mode.
➜ The selected source 
CD or TUNER is shown. Display sequence scrolls SET ON TIME and TIMER flashes. The clock digits for the hours flash.
4Turn VOLUME to set the hours: clockwise for hours up;
5Press TIMER ON•OFF again.
➜The clock digits for the minutes flash.
6Turn VOLUME to set the minutes: clockwise for minutes up;
7Press TIMER ON•OFF to confirm the time.
➜The timer is now set and activated.
Activating and deactivating
TIMER
●In standby or during playback, press TIMER ON•OFF once.
➜ Display shows TIMER if activated, and disappears if deactivated.
English
19