Amana RS2320006 Self-Cleaning, Interrupting the self-clean cycle, Delayed Self-clean Cycle

Genesis Control Programming Instructions

7.Oven will automatically begin to heat at selected start time.

∙OVEN ON light will turn on when oven begins to heat.

∙To adjust cook time, press COOK/CLEAN TIME pad twice while the remaining cook time is displayed. Cook time can then be adjusted.

∙When cooking time has elapsed an end of cycle signal sounds and END will be displayed. Oven signal sounds 4 times, then once every 10 seconds until oven control knob is turned to OFF. Knob must be turned to OFF for oven to stop shut off.

8.Turn knob to OFF to cancel baking.

Self-Cleaning

Self-clean feature uses high oven temperature to clean oven interior. For the oven to operate through a complete self-clean cycle, the self-clean must be set when the oven is cool.

1.Prepare oven for self-cleaning. Oven bottom recess must be checked for grease build up before beginning a self-clean cycle.

2.Close door.

3.Push and turn oven temperature knob to CLEAN position.

∙The default self-clean cycle length of 3 hours will display.

4.Set cycle length for self-clean.

∙Use slew pads to adjust time as necessary before oven indicator light turns on.

∙Clean cycle can be set from two to four hours in five minute increments.

∙Default setting for the cycle is three hours.

5.Self-clean begins.

∙OVEN ON indicator light will be on and will remain on until the end of the cycle.

∙At the end of the self-clean cycle, the OVEN ON indicator light will shut off.

∙At the end of the self-clean cycle, the oven will stop heating, however, oven will remain hot.

∙The LOCKED indicator light will remain on until oven reaches a cooler temperature. LOCKED light will flash while door is unlocking, and then shut off when door has unlocked. Oven cavity will be hot to the touch.

∙DO NOT attempt to open door prior to LOCKED indicator light shutting off. When oven is cool, turn oven knob to OFF.

Interrupting the self-clean cycle

To stop a self-clean cycle that has already started follow these steps. If an interruption occurs mid cycle, the oven will remain locked, even though the cycle has stopped, until the oven cavity has cooled to a lower temperature.

1.Turn oven temperature knob to OFF position.

2.When oven has cooled to a lower temperature, LOCKED light turns off. Door can be unlocked.

∙DO NOT force door. This can cause damage to the latch.

Delayed Self-clean Cycle

Self-clean feature uses high oven temperature to clean oven interior. Set oven to begin and end cleaning at later time. Range control begins the self-clean at your specified start time.

1.Prepare oven for self-cleaning. Oven bottom recess must be checked for grease build up before beginning a self-clean cycle.

2.Close door.

3.Press START COOK/CLEAN pad.

4.Set starting time for the cleaning cycle.

∙Default time is current time of day.

∙Start time can be set from current time to current time plus 11 hours and 59 minutes.

5.Turn oven temperature knob to CLEAN.

∙Default self-clean cycle length of 3 hours will display.

6.Set cycle length for self-clean.

∙Use slew pads to adjust time as necessary.

∙Clean cycle can be set from two to four hours in five minute increments.

∙Default setting for the cycle is three hours.

7.Self-clean cycle is set.

∙Oven cannot be used until completion of the self-clean cycle.

∙Self-clean cycle will begin at selected start time.

∙To view start time, press the START COOK/CLEAN pad.

∙OVEN ON indicator light will turn on when the self-clean cycle begins and will remain on until the end of the cycle.

∙To view the clean cycle time, press the COOK/CLEAN TIME pad.

∙At the end of the self-clean cycle, OVEN ON indicator light shuts off and the oven does not maintain the high temperatures. Oven will still be hot, however.

∙The LOCKED indicator light will remain on until oven reaches a cooler temperature. LOCKED light will flash while door is unlocking, and then shut off when door has unlocked. Oven cavity will be hot to the touch.

∙DO NOT attempt to open door prior to LOCKED indicator light shutting off. Once oven is cool, turn oven knob to OFF position.

Interrupting the self-clean cycle

To stop a self-clean cycle that has already started follow these steps. If an interruption occurs mid cycle, the oven will remain locked, even though the cycle has stopped, until the oven cavity has cooled to a safe temperature.

1.Turn oven temperature knob to OFF position.

2.When oven has cooled to a lower temperature, LOCKED light shuts off. Door can be unlocked.

∙DO NOT force door. This can cause damage to the latch.

RS2320006 Rev. 0 C−4