Avanti FFBM921PS, FFBM920W Operating Your Appliance,  Temperature Control Panels

Page 9

OPERATING YOUR APPLIANCE

Temperature Control Panels

Refrigerator Temperature Control

Freezer Temperature Control

MAX MED MIN

Setting the Temperature Control

Your refrigerator has a separate control for regulating the temperature for each section independently. The temperature control is located at the rear of each section (refrigerator / freezer). (See the graphics shown above).

The first time you turn the unit on, set the temperature control to “MAX” in refrigerator section and “MAX” in freezer section.

The range of the temperature controls are from position “MIN” to “MAX” the coldest in refrigerator section and from position “MIN” the warmest to “MAX” the coldest. After 24 to 48 hours, adjust the temperature control to the setting that best suits your needs. The setting of “MED” in freezer section and the mid range marked “●” between “MIN” and “MAX” in refrigerator section should be correct for home or office refrigerator use.

NOTE:

AMBIENT TEMPERATURES BELOW 50ºF (10ºC) WILL AFFECT THE OPERATION OF YOUR REFRIGERATOR. WHEN THE UNIT IS PLACED IN AN AREA WHERE THE TEMPERATURE DROPS LOWER THAN 50ºF (10ºC), SET THE TEMPERATURE CONTROLS SELECTORS TO “MAX”

IN BOTH THE REFRIGERATOR AND FREEZER SECTIONS.

NOTE:

IF THE UNIT IS UNPLUGGED, HAS LOST POWER, OR IS TURNED OFF, YOU MUST WAIT 3 TO 5 MINUTES BEFORE RESTARTING THE UNIT. IF YOU ATTEMPT TO RESTART BEFORE THIS TIME DELAY, THE REFRIGERATOR-FREEZER WILL NOT START.

TURNING THE REFRIGERATOR TEMPERATURE CONTROL TO “OFF” POSITION STOPS THE COOLING CYCLE BUT DOES NOT SHUT OFF THE POWER TO THE UNIT.

Using Your Ice Cube Tray

Recommended thermostat setting for ice making is position “MAX”.

Fill the ice cube tray (two thirds of it) with cold water or with any liquid suitable for freezing and place the tray on the bottom of the freezer to freeze properly.

Dry the tray, otherwise it may stick to the bottom of the freezer.

The best method to get ice cubes out of the tray is to hold the tray under cold tap water for a second.

To eject the ice cubes from the tray, place over the ice bucket and twist slightly

9

Image 9
Contents Model Numbers / No. de Modelos Manual DE InstruccionesTable of Contents Your safety and the safety of others are very important Refrigerator SafetyImportant Safeguides If YOU Need Service Avanti Customer ServiceHelp US Help YOU Read this guide carefullyParts and Features Installation Instructions  Before Using Your Appliance Installation of Your Appliance  Electrical Connection  Extension Cord Reversing the Door Swing of Your Appliance Freezer Temperature Control  Temperature Control Panels Setting the Temperature Control  Using Your Ice Cube TrayCare and Maintenance  Energy Saving Tips Problems with Your APPLIANCE? Troubleshooting GuideProblem Possible Cause Wiring Diagram Service for Your ApplianceService under warranty WarrantyYour Avanti Products Staple your sales receipt here. ProofInstrucciones Para LA Instalacion Instrucciones EN EspañolAntes de usar su equipo Instalación de su electrodomésticoAdvertencia Como Cambiar LA Direccion DE Apertura DE LA PuertaComo graduar la temperatura USO DE LA Cubetera DE Hielo Cuidados EN LOS Periodos DE AusenciaCuidado Y Mantenimiento Consejos para ahorrar energía  Promote better products Did You Purchase An Additional WarrantyAvanti Registration Form As Your Primary Residence, Do You