Care and Maintenance

CLEANING YOUR WINE CHILLER

∙Turn off the power, unplug the appliance, and remove all items including shelves.

∙Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water.

∙Wash the shelves with a mild detergent solution.

∙Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.

∙Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth.

∙Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless steel with steel particles and rusting may occur.

POWER FAILURE

∙Most power failures are corrected within a few hours and should not affect the temperature of your appliance if you minimize the number of times the door is opened. If the power is going to be off for a longer period of time, you need to take the proper steps to protect your contents.

MOVING YOUR WINE CHILLER

∙ Remove all items.

∙ Securely tape down all loose items (shelves) inside your appliance. ∙ Turn the adjustable leg up to the base to avoid damage.

∙ Tape the door shut.

∙ Be sure the appliance stays secure in the upright position during transportation. Also protect outside of appliance with a blanket, or similar item.

REVERSING THE DOOR SWING OF YOUR APPLIANCE

This appliance has the capability of the door opening from either the left or right side. The unit is delivered to you with the door opening from the left side. Should you desire to reverse the opening direction, please call service for reversal instructions.

CHARCOAL FILTRATION SYSTEM

Your wine is a living object that breathes through the cork of its bottle. In order to preserve the quality and taste of your fine wines, they must be stored at the ideal temperature and ambient conditions.Your cellar is equipped with an active charcoal filtration system to ensure air purity, cooling efficiency, and to maintain an odor free cabinet for the storage of your fine wines. The filter assembly is located at the rear panel inside your cellar.

Keep in mind, that this filter must be changed every 12 months. To replace your filter:

1	Remove the bottles of wine stored on the
	two (2) shelves in front of the filter.
2	Remove the shelves and set aside to be
	replaced once you have changed the filter
3	Hold the filter and turn it at 90 degrees in
	the anti-clockwise direction and then pull it
	out.
4	Remove the existing filter and replace
	with a new one.
5	Put the new filter into the hole and then
	turn the filter at 90 degrees in clockwise
	direction..
	Figure / Image for reference only.