INSTALLING STAINLESS STEEL HANDLE
This wine cellar includes a stainless steel handle that is not required to operate this unit. To install the handle please follow the below instructions:
For your convenience the screws used in the installation of the handle have been put in place at the factory.
1.Pull away the door gasket in the area where the handle is to be installed on the left side as shown below in Illustration # 1. The gasket is easily displaced by hand, no tools are necessary.
2.Align the handle with the screws installed. Tighten the screws using a Phillips head screwdriver until the handle sets both flush and secured tightly against the door frame. (DO NOT over tighten as this will cause damage to the handle assembly).
3.Replace the door gasket to its original position.
4.If you choose not to use the handle supplied, simply follow step 1 to access the installation screws and remove them and then place the two decorative plugs into the two holes separately. Continue on to step 3 to replace the door gasket to its original position.
Illustration # 1 |
| Illustration # 2 | ||
|
|
|
|
|
1 | Gasket | 3 | Phillips Head Screw Driver | |
| 2 | Phillips Head Screw | 4 | Handle |
9