Installation

1Fit the two plastic wall spacers supplied with the appliance, rotating 1/4 turn to the condenser at the back of the appliance.

2Locate the appliance on a smooth surface.

3To ensure it is standing upright adjust the two front feet by turning clockwise or anti-clockwise, until it is in firm contact with the floor. Correct adjustment of feet avoids excessive vibration and noise.

4A special receptacle is supplied to store the mains plug during transit. The receptacle is fixed at the back of the cabinet on the side of the compressor. Gently remove the plug from the receptacle. Never pull the mains cord, you may damage the appliance. In case of transportation, ensure you locate the plug in the receptacle provided to avoid transit damage.

5The space in the room where the appliance is installed must not be smaller than 10 cubic metres.

6Fit the front grille supplied with your appliance as shown in the diagram.

Wall spacers

Condenser

Adjustable feet

Plug receptacle