Beko TZDA 629 F manual Electronic card

Page 4

IMPORTANT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INSTALLATION INSTRUCTIONS

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1.

The space in the room where the appliance is installed must not be smaller

 

 

than 10 cubic metres.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2.

If possible avoid placing the appliance near cookers, radiators or in direct

 

 

sunlight as this will cause the compressor to run for long periods. If installed

 

 

next to a source of heat or refrigerator, maintain the following minimum side

 

 

clearances:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

From Cookers

2"

 

(50 mm)

 

 

 

 

 

 

 

 

 

 

From Radiators

12" (300 mm)

 

 

 

 

 

 

 

 

 

 

From Refrigerators or Larder Fridge

1"

 

(25 mm)

 

 

 

 

 

 

 

 

3.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Make sure that sufficient room is provided around the appliance to ensure free

 

 

air circulation. Allow a minimum of 60 mm (2.4 inches) between the top of the

 

fridge and the ceiling or the underside of a wall cupboard.

4.

Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn

 

to the condenser at the back of the appliance (See diagram).

5.

The appliance should be located on a smooth surface.

 

 

 

 

 

 

Electronic card

 

 

(covered by plastic cover)

 

The two front feet can be adjusted as required.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

To ensure that,your appliance is standing

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

upright adjust the two front feet by turning

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

clockwise or anti-clockwise, until the product

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

is in firm contact with the floor. Correct

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

adjustment of feet avoids excessive

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6.

 

vibration and noise.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Refer to "Cleaning and Care" section to

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

prepare your appliance for use.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

7.A special receptacle is supplied to store the mains plug during transit.

The receptacle is fixed at the back of the cabinet, on the right hand side of the compressor. (See diagram) Gently remove the plug from the receptacle. Never pull the mains cord, you may damage the appliance. In the case of transportation, ensure you locate the plug in the receptacle provided to avoid transit damage.

5

INDICATOR LIGHTS

There are three coloured indicator lights located on the front of the appliance which shows the operating mode of the freezer.

Indicator lights slightly flicker. This is by design and not a fault, don’t worry. This low energy consumption design is developed to achieve the lowest possible electiricty use.

Green Indicator (1)

Illuminates when the appliance is connected to the mains and will glow as long as electricity is available. The green indicator does not give any indication of the temperature inside the freezer.

Amber Indicator (2)

This indicator will glow when the fast freeze button (4) is on and will continue to glow for 34 hours until the fast freeze button is turned off. It will automatically turn off after 34 hours otherwise, the compressor will run continuously while fast freeze button is on. Fast freeze operation is for freezing fresh food (See Freezing Fresh Food, page 9).

Red Indicator (3)

Red indicator light has a built-in delay. Once switching on, it will not come on for 24 hours.

This indicator will glow when the internal temperature rises above -5°C and it will automatically de-activate when the internal temperature falls below -9°C

Thermostat Knob (5)

Thermostat knob is located on the indicator light set.

Temperature Display (6)

Display shows actual internal temperature. When you switch on fast frezee, it will display - 27 °C for 5 seconds. When you rotate the knob, it displays the new setting for 5 seconds and then reverts back to actual temperature.

IMPORTANT :

When you press the fast freeze button (4), there may be a short delay before the compressor starts to operate. This is normal and not a compressor fault, don’t worry.

-E0 flashes on display (6) if there is a freezer sensor failure.

-E1 flashes on display (6) if there is a defrost sensor failure.

-E4 blinks on display if there is a heater failure.

4

5

6

2

1

3

 

 

 

6

 

 

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Cu.ft. Frost Free Tall Upright Freezer Tzda 629 F Guarantee Details HOW to Obtain Service PerformanceElectrical Requirements IMPORTANT! Fitting a Different PlugElectronic card Starting Reservoir DOS and Donts 15 14 Guarantee Details

TZDA 629 F specifications

The Beko TZDA 629 F is a standout model in the realm of upright freezers, designed to cater to the needs of families and individuals who require efficient and ample frozen storage. With a sleek and modern aesthetic, this freezer is both functional and stylish, making it a worthy addition to any home.

One of the standout features of the Beko TZDA 629 F is its impressive storage capacity. It boasts a generous net capacity of 215 liters, allowing ample space for bulk frozen foods, from meats and vegetables to prepared meals. The various storage compartments and drawers are designed to optimize organization, ensuring that users can easily access their frozen items without hassle.

Energy efficiency is another key characteristic of the Beko TZDA 629 F. The model is rated with a high energy efficiency class, helping users to minimize their energy consumption and lower their utility bills. This is especially appealing for those who are environmentally conscious and looking for ways to reduce their carbon footprint.

The Beko TZDA 629 F is equipped with the brand's innovative NeoFrost Dual Cooling Technology. This technology ensures that the freezer maintains a consistent temperature and humidity level, preventing frost from building up. The dual cooling system helps to preserve the quality and freshness of food items, preventing freezer burn, and keeping flavors intact.

Furthermore, its Fast Freeze function allows users to freeze fresh food quickly, which is ideal for preserving nutrients and locking in freshness. This feature proves invaluable during grocery shopping, as it helps to prevent spoilage of newly added items.

The appliance also includes an efficient electronic control system, making it simple to adjust settings and monitor the temperature. Additionally, the Beko TZDA 629 F is designed with a high-quality stainless steel finish, ensuring durability and ease of maintenance, while also enhancing the overall aesthetic of the kitchen.

In terms of safety and convenience, the freezer comes with a visual and audible alarm that alerts users in the event of temperature fluctuations, ensuring that food remains safely frozen. With its combination of style, efficiency, and advanced technology, the Beko TZDA 629 F serves as a reliable solution for all your freezing needs. Whether you are stockpiling for a rainy day or simply need additional space for your frozen goods, this model is sure to exceed expectations.
Top Page Image Contents