3Installation
Transportation Instructions
1.The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation.
2.If during the course of transport the appliance has to be transported horizontally, it must only be laid on its right hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle.
3.Failure to comply with the above instructions could result in damage occuring to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.
4.The appliance must be protected against rain, moisture and other atmospheric influences.
5.Empty any water in the drain tray before moving see section “Defrosting” and “Cleaning & Care” for further information
IMPORTANT : Make sure the plastic evaporating pan at the back of the product collects water properly. IMPORTANT: Care must be taken while cleaning / carrying the appliance to avoid touching the bottom of the condenser metal wires at the back of theappliance as you might injure your fingers and hands.
IMPORTANT: This appliance is not designed for stacking with any other appliance.When positioning your appliance, take care not to damage
your flooring, pipes,wall coverings etc. Do not move the appliance by pulling by the door or handle.Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.
IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying
/moving the appliance, to avoid the mains cable becoming cut or damaged.”Do not allow children to play with the appliance or tamper with the controls.
BEKO declines to accept any liability should the instructions not be followed.
Installation Instructions
1.If possible avoid placing the appliance
near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:
From Cookers 2” (50 mm) From Radiators 12” (300 mm)
From Refrigerators or Larder Fridge 1” (25 mm)
2.No gap is required at sides and top. See item 3 below to ensure a gap is obtained at the rear of the appliance. If a gap is available on side and top, retain it if possible as it would improve the air circulation around the appliance.
8
EN