3Installation
3.1. Right place for installation
Contact the Authorized Service for the product's installation. To ready the product for installation, see the information in the user guide and make sure the electric and water utilities are as required. If not, call an electrician and plumber to arrange the utilities as necessary.
BWARNING: The manufacturer assumes no responsibility for any damage caused by the work carried out by unauthorized persons.
BWARNING: The product’s power cable must be unplugged during installation. Failure to do so may result in death or serious injuries!
WARNING: : If the door span is too Anarrow for the product to pass, remove
the door and turn the product sideways; if this does not work, contact the authorized service.
•Place the product on a flat surface to avoid vibration.
•Place the product at least 30 cm away from the heater, stove and similar sources of heat and at least 5 cm away from electric ovens.
•Do not expose the product to direct sunlight or keep in damp environments.
•The product requires adequate air circulation to function efficiently. If the product will be placed in an alcove, remember to leave at least 5 cm distance between the product and the ceiling and the walls.
•Do not install the product in environments with temperatures below
3.2. Attaching the plastic wedges
Use the plastic wedges in the provided with the product to provide sufficient space for air circulation between the product and the wall.
1.To attach the wedges, remove the screws on the product and use the screws provided with the wedges.
2.Attach 2 plastic wedges on the ventilation cover shown as j in the figure.
Refrigerator / User Guide | 7 / 24 EN |
|
|
|
|