Electrical Requirements

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply.

Rating label is on the left hand side of fridge inner liner.

We recommend that this appliance is connected to the mains supply via a suitable switched and fused socket in a readily accessible position.

Should the mains lead of the appliance become damaged or should it need replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a BEKO Authorised Service Agent.

WARNING! THIS APPLIANCE MUST BE EARTHED

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord could cause a shock hazard if inserted into a socket elsewhere in the house.

The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

TRANSPORTATION INSTRUCTIONS

1.The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation.

2.If during the course of transport the appliance has to be transported horizontally, it must only be laid on its right hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle.

3.Failure to comply with the above instructions could result in damage occuring to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.

4.The appliance must be protected against rain, moisture and other atmospheric influences.

5.When positioning your appliance take care not to damage your flooring, pipes, wall coverings etc. Do not move the appliance by pulling by the door or handle.

6.Empty any water in the drain tray before moving. See section ‘Defrosting’ and ‘Care & cleaning’ for further information.

7.Make sure that the defrost water pipe at the back of the product is fixed to the plastic evaporating pan on the top of the compressor, to avoid defrost water

spillage on the floor.

IMPORTANT : Care must be taken while cleaning / carrying the appliance to avoid touching the bottom of the condenser metal wires at the back of the appliance as you might injure your fingers and hands.

Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.

IMPORTANT! FITTING A DIFFERENT PLUG As the colours of the wires in the

mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

(See diagram).

1.Connect the green-yellow or green (Earth) wire to the terminal in the plug marked 'E' or with

the symbol or coloured green and yellow or green.

2.Connect the blue (Neutral) wire to the terminal in the plug marked 'N' or coloured black.

GREEN &

6mm.

YELLOW

32mm.

GREEN

BROWN

6mm

22mm.

RED

BLUE

12mm.

.6mm

BLACK

CORD GRIP

FUSE

FITTED WITH BS 1362 13A FUSE ALWAYS FIT BS 1362 REPLACEMENT CARTRIDGE FUSE

"IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying / moving the appliance, to avoid the mains cable becoming cut or damaged."

Do not allow children to play with the appliance or tamper with the controls. BEKO plc declines to accept any liability should the instructions not be followed.

IMPORTANT

INSTALLATION INSTRUCTIONS

1.The space in the room where the appliance is installed must not be smaller than 10 cubic metres.

2.This appliance has been designed to operate in ambient temperatures up to 32 degrees C (90 degrees F) and is equipped with Low Ambient Switch which ensures that the frozen food in the freezer will not defrost even if the ambient temperature falls to 10 °C.

Do not put your fridge° freezer in a cold room where the temperature is likely to go below +5 degrees C (41 degrees F) during night time and/or especially in winter.

3.Connect the brown (Live) wire to the terminal in the plug marked 'L'

or coloured red.

With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or in the main fuse box.

If in doubt contact a qualified electrician.

This fridge freezer has been designed to operate in ambient temperatures

between +5 and +32 degrees C (41 and 90 degrees F) Therefore if the appliance is installed in an unheated/cold room (eg: conservatory/annex/ shed/garage etc) then the appliance will not operate causing the freezer compartment to run warmer and as a result the storage time of frozen food may be reduced.

FC 175F specifications

The Beko FC 175F is a standout freezer designed for those seeking efficient storage solutions in compact spaces. This upright freezer is celebrated for its blend of versatility, spaciousness, and energy efficiency, making it an ideal choice for households requiring additional freezing capabilities.

One of the primary features of the Beko FC 175F is its impressive storage capacity. With an ample net volume of around 175 liters, this freezer offers enough space to accommodate a variety of food items, from meats and vegetables to frozen meals and desserts. The adjustable shelving allows users to organize their items effectively, maximizing the use of available space. This flexibility ensures that even larger items can be stored with ease.

The Beko FC 175F also boasts several advanced technologies aimed at enhancing user convenience and food preservation. One notable feature is its fast freeze function, which rapidly lowers the temperature to lock in freshness and nutrients when new items are added. This function is particularly useful during the busy seasons of cooking and food preparation, ensuring that food maintains its quality.

Energy efficiency is another critical characteristic of this freezer. Rated with a low energy consumption level, the FC 175F helps users reduce their electricity bills. Its A+ energy class rating indicates that it operates efficiently, making it an environmentally friendly option that contributes to lower carbon footprints.

In terms of design, the Beko FC 175F is user-friendly, featuring a reversible door that allows for installation flexibility in various kitchen layouts. It includes a mechanical control system, enabling straightforward temperature settings and management.

With a robust build and an attractive white exterior, the freezer blends seamlessly into different kitchen decors. Furthermore, its operation is relatively quiet, providing a peaceful environment without disruptive noise.

Overall, the Beko FC 175F stands out for its combination of capacity, technology, and energy efficiency. It's a reliable choice for anyone in need of additional freezing space, combining practical features with a sleek design that meets modern household demands. Whether you're stockpiling groceries or preparing for seasonal celebrations, this freezer is a smart addition to any kitchen.